Audi Q3: Assist systems
Assist systems
- General information
- Surrounding area detection
- Driving information
- Driver assistance
- Cruise control system
- Adaptive cruise assist
- Limitations
- Display overview
- Using adaptive cruise assist
- Switching lane guidance on and off
- Predictive control
- Setting the distance
- Overriding control
- Driver intervention request
- Distance warning
- Lane departure warning
- Audi pre sense
- Audi pre sense basic
- Adjusting Audi pre sense
- Side assist
- Adjusting side assist
- Emergency assist
- Parking and maneuvering
READ NEXT:
General information
Safety precautions
WARNING
As the driver, you are always completely responsible
for all driving tasks. The assist
systems cannot replace the driver's attention.
Give your full attention to drivin
Surrounding area detection
Sensor and camera coverage areas
Fig. 88 Sensor coverage area
Fig. 89 Rearview camera coverage area
The assist systems analyze the data from various
sensors and cameras installed in the vehicle. Do
SEE MORE:
Drive Axle, Removing and Installing, Drive Axle with Triple Roller Joint
AAR3300i, Mounted on Transmission Stub Shaft
Special tools and workshop equipment
required
Slide Hammer Set -VW771-
Tensioning Strap -T10038-
Puller - Driveshaft -T10382-
Torque Wrench 1332 40-200Nm -VAG1332-
Digital Torque Wrench -VAG1756A-
Removing
- Loosen the drive axle threaded connection on the wheel side.
Refer
Vehicle Alignment
Axle Alignment Information
Wheel alignment must only performed using VW/Audi-approved
wheel alignment equipment.
Each time wheels are aligned, both front and rear wheels
must be aligned.
Otherwise, proper vehicle drivability cannot be ensured.
Otherwise centering of toothed shaft cannot be g
© 2019-2026 Copyright www.auq3.net | 0.0139
