Audi Q3: Alternative routes
Applies to: vehicles with navigation system
.png)
Fig. 134 Alternative routes in the overview map
Opening alternative routes
Requirement: route guidance must be started and the map must be displayed.
- Press on
.png)
in the side menu
on the map
.png)
fig. 131.
- Current route
The distance to the destination and the calculated arrival time will be displayed for the current route.
- Alternative route
The difference in travel time compared to the selected route will be displayed.
Displaying alternative routes in the foreground
- Press
.png)
in the corresponding
information window,
or - Press and hold the information window for the
corresponding alternative route (for example,
2 fig. 134).
Select route
- Press on the information window for the corresponding route (for example 2).
READ NEXT:
Additional functions
Favorites
Applies to: vehicles with navigation system
In the favorites, you can call up frequently-used
destinations as well as your home/business address.
Accessing favorites
Applies to: MMI: Selec
Satellite map
Applies to: vehicles with navigation system and satellite map
You can display the navigation map with satellite
images.
Requirement: the MMI must be connected to the
Internet.
Applies to: MMI: Sele
Map update
Introduction
Applies to: vehicles with navigation system
You can update the map data in the MMI with a
map update. The functions depend on the country
and vehicle equipment.
Map update through onlin
SEE MORE:
Leaking or Damaged Components except A/C Compressor, Reservoir or
Receiver/Dryer
The refrigerant circuit was completely empty (for example
with larger leak or cracked hose)
Note
In the event of only a minor leak with slow escape of
refrigerant (e.g. at a small leakage point), the amount of
refrigerant oil lost and the amount of moisture penetrating is
not s
Sunlight Photo Sensor -G107-, Removing and Installing
Note
The Sunlight Photo Sensor -G107- is only installed with an
automatic climate control system.
Check the Sunlight Photo Sensor -G107- using the Vehicle
Diagnostic Tester in the "Guided Fault Finding" function, A/C
system.
Removing
- Using a 0.4 mm feeler gauge -1-,
© 2019-2025 Copyright www.auq3.net
