Audi Q3: Display overview
Applies to: vehicles with adaptive cruise assist
.png)
Fig. 97 Instrument cluster: display in speedometer
.png)
Fig. 98 Instrument cluster: driver assistance display
Indicator lights and messages in the speedometer 1 - 3 inform you about the driving situation and the settings. In the Driver assistance display 4 - 11, you can find more detailed information about the system. The displays depend on the country and equipment.
Display in the speedometer
- Marking for the set speed
- Current vehicle speed
- Available speed range for adaptive cruise assist (example)
Image in the Driver assistance display
The display only appears when the Driver assistance display is open in the trip computer.
- Messages and settings
- Your vehicle
- Detected vehicle driving ahead
- Messages and settings
- Set target distance
- If you fall below the set distance, the distance bars turn red from the bottom upward.
- Lane departure warning availability
- Availability of lane guidance for adaptive cruise assist
Indicator lights
.png)
- The speed/distance control is
active. No
vehicles were detected ahead. The stored speed
is maintained.
.png)
- The speed/distance control is
active. A vehicle
was detected ahead. The system controls the
speed and distance from the vehicle driving
ahead, and accelerates and brakes automatically.
.png)
- The speed/distance control is
active but the
vehicle is not ready to drive. A vehicle was detected
ahead. Your vehicle is stationary and will
not start driving automatically.
.png)
- The speed/distance control is
active but the
vehicle is not ready to drive. No vehicles were detected
ahead. Your vehicle is stationary and will
not start driving automatically.
.png)
- The automatic braking is not
enough to
maintain a sufficient distance from a vehicle driving
ahead. You must intervene.
.png)
- Lane guidance is active.
.png)
- Lane guidance is switched on
but not active.
.png)
- The limits of the system have
been reached
Take over steering.
.png)
- The indicator light turns on
if the
steering intervention request is providing a warning.
Always keep your hands on the steering wheel so you can be ready to steer at any time.
WARNING
Observe the safety precautions and note the limits of the assist systems, sensors, and cameras.
READ NEXT:
Using adaptive cruise assist
Applies to: vehicles with adaptive cruise assist
Fig. 99 Lever: using adaptive cruise
assist
Fig. 100 Operating lever: changing the speed
Switching on
To switch on the adaptive cruise assist, pul
Switching lane guidance on and off
Applies to: vehicles with adaptive cruise assist and lane guidance
Fig. 101 Turn signal lever: button for lane guidance and
lane departure warning
Within the limits of the system, lane guidance
provi
Predictive control
Applies to: vehicles with adaptive cruise assist and predictive
control
General information
With predictive control, efficiency assist adapts
the speed set in the adaptive cruise control 1
fig. 97 b
SEE MORE:
Jump starting
Preparation
You should only perform the steps that follow if
you have the necessary tools and technical expertise.
If the engine does not start because the vehicle
battery is drained, you can jump start your vehicle
using another vehicle. Jump start cables are
needed to do this.
Both vehicle batteri
Wheel Bearing Housing Bonded Rubber Bushing, Replacing
Wheel Bearing Housing Bonded Rubber Bushing, Replacing, FWD Vehicles
Special tools and workshop equipment
required
Bearing Installer - Control Arm -3346-
Bearing Installer - Carrier Bearing -3350-
Fitting Sleeve -3378-
Torque Adapter -3390-
Torque Wrench 1332 40-200Nm -VAG1332-
Rem
