Audi Q3: Interrupting the park assist
	
						
			Applies to: vehicles with park assist
Park assist will be canceled automatically in the
following scenario:
	- You switch the system off.
- You start steering.
- The speed is too high.
- The time limit is exceeded.
- An obstacle is detected.
- ESC intervenes.
Resume control of the vehicle, end the park assist
manually, or:
	- You can resume the parking process in some
	situations. Press the .png) button 
	in the center
	console. button 
	in the center
	console.
- To continue exiting the parking space, switch
	the engine off and on. Press the
	.png) button in
	the center console. button in
	the center console.
WARNING
Observe the safety precautions and note the
limits of the assist systems, sensors, and
cameras.
Messages
Applies to: vehicles with park assist
If the .png) ,
,
.png) or
 or
.png) indicator light turns on, the
park assist is not available or was interrupted.
 indicator light turns on, the
park assist is not available or was interrupted.
A message that indicates the cause and possible
solution may appear with some displays. The
weather conditions may be too poor or a sensor
may be covered. Clean the area in front of the
sensors and try to turn the system on
again later.
If the malfunction remains, drive to an authorized
Audi dealer or authorized Audi Service Facility
immediately to have the malfunction corrected.
READ NEXT:
	
   Applies to: vehicles with telephone
You can operate various telephone functions easily
through the MMI in your vehicle.
Depending on the country and the vehicle equipment,
the following options may b
   
   
 
   SEE MORE:
	
   Sensor and camera coverage areas
Fig. 88 Sensor coverage area
Fig. 89 Rearview camera coverage area
The assist systems analyze the data from various
sensors and cameras installed in the vehicle. Do
not use any assist systems if there is damage in
there area of the sensors and cameras or on the
veh
   
   
 
	
   Housing, Removing and Installing
Removing  
- Remove the sealing plugs.
- Remove the clamping screw -3- 
until it stops using a screwdriver -4-.
- Press the housing retaining bracket 
-2- inward.
- Remove the housing -1- from the 
bracket -arrow B-.
Installing
Install i