Audi Q3: Adjusting side assist
Applies to: vehicles with side assist
You can adjust the side assist to your preferences.
The settings depend on the vehicle equipment.
- Applies to: MMI: Select on the home screen: VEHICLE > Driver assistance > Side assist.
Possible settings:
The system can be switched on and off. If the system is switched on, the displays in the exterior mirrors will turn on briefly each time the ignition is switched on.
Brightness - Change the brightness only when side assist is switched on, so that the selected setting can be checked in the exterior mirror displays.
Adjust the brightness to a level where the display will not interfere with your view ahead.
Because the display brightness automatically adapts to the ambient light, it may have already been adjusted to the highest or lowest setting during the automatic adaptation.
Messages
Applies to: vehicles with side assist
If .png)
or
.png)
displayed when there is a
malfunction,
the side assist functions may be unavailable
or may be limited.
A message that indicates the cause and possible
solution may appear with some displays. The
weather conditions may be too poor or a sensor
may be covered. Clean the area of the sensors at
the rear corners of the vehicle .png)
fig. 91 and try to turn the system on again later.
If the malfunction remains, drive to an authorized Audi dealer or authorized Audi Service Facility immediately to have the malfunction corrected.
READ NEXT:
Emergency assist
Description
Applies to: vehicles with emergency assist
General information
Within the limits of the system, emergency assist
can detect inactivity from the driver. In these instances,
the system will
Introduction
Depending on the vehicle equipment, various
parking aids will help you when parking and maneuvering.
Parking aid
The parking aid plus assists you while parking
using audio and visual signals to warn y
SEE MORE:
Traffic incidents
Introduction
Applies to: vehicles with navigation system and online traffic
information
Fig. 135 Traffic information overview
Open traffic information
Requirement: the map must be displayed.
Press on the traffic jam symbol in the side
menu on the map fig. 131.
Display traffic report details
Window Regulator Motor, Removing and Installing
Removing
Note
The window regulator motor can be removed or installed with
the motor or door window in any position.
- Remove the rear door trim panel. Refer to
→ Body Interior; Rep. Gr.70; Rear Door Trim Panels; Rear Door
Trim Panel, Removing and Installing.
-
