Audi Q3: Infotainment system
Infotainment system
READ NEXT:
Introduction
Applies to: vehicles with telephone
You can operate various telephone functions easily
through the MMI in your vehicle.
Depending on the country and the vehicle equipment,
the following options may b
Setup
Connecting a mobile phone via Bluetooth
Applies to: vehicles with telephone
Requirement: the vehicle must be stationary and
the ignition must be switched on. The Bluetooth
settings must be open on youSEE MORE:
Chip Card Reader Control Module, Removing and Installing
The Chip Card Reader Control Module -J676--1-
is located inside the glove compartment
-2-.
Removing
- Turn off the ignition and all electrical equipment and
remove the ignition key.
- Remove the glove compartment. Refer to
→ Body Interior; Rep. Gr.68; Storage Co
Heater and A/C Unit, Removing and Installing
Special tools and workshop equipment
required
Hose Clamps - Up To 25mm -3094-
Engine Bung Set -VAS6122-
Compressed air gun, commercially available
Removing
WARNING
There is a risk of scalding from hot steam and
coolant.
The coolant system is under pressure when the eng
© 2019-2026 Copyright www.auq3.net | 0.0121
