Audi Q3: Additional settings
Audi Q3 (F3) 2018-2026 Owner's Manual / Additional settings
READ NEXT:
System settings
Introduction
General settings are described in this chapter.
You can find specific settings in the chapters
about those settings. The available settings depend
on the vehicle equipment.
Date and time
Connected devices
Displayed connected devices
Requirement: the vehicle must be stationary and
the ignition must be switched on.
Applies to: MMI: Select on the home screen:
SETTINGS > Connected devices.
Possible
Legal information
General information
Information on the software licenses can be
found online at www.audi.com/softwareinfo.
Multi Media Interface
Applies to: MMI: Select on the home screen:
SETTINGS > General.
SEE MORE:
Overview - Electric Vacuum Pump
1 - Brake System Vacuum Pump -V192-
Allocation, refer to the Parts Catalog.
Installed location: in the engine compartment over the engine
transmission separating point.
Do not disassemble
Removing and installing, refer to
→ Chapter "Electric Vacuum Pump, Removing and
Tire Pressure Monitoring System
Tire Pressure Monitoring with Pressure Sensor
WARNING
If tire sealant was used, then the wheel electronics
on that particular wheel must be replaced.
The wheel electronics, that is, the system pressure sensor,
forms a physical unit with the valve.
Note
The lettering on th
© 2019-2026 Copyright www.auq3.net | 0.0094
