Audi Q3: Introduction
Applies to: vehicles with telephone
You can operate various telephone functions easily
through the MMI in your vehicle.
Depending on the country and the vehicle equipment,
the following options may be available:
- Connecting a cell phone with Bluetooth
- Using two telephones
- Using the Audi phone box
WARNING
Note
Read the information about Audi connect, and
be sure to note the connectivity costs section.
Tips
- The Bluetooth connection range is limited
to inside the vehicle.
- A selection of supported Bluetooth devices
can be found in the database for tested mobile
devices at www.audi.com/bluetooth.
READ NEXT:
Connecting a mobile phone via Bluetooth
Applies to: vehicles with telephone
Requirement: the vehicle must be stationary and
the ignition must be switched on. The Bluetooth
settings must be open on you
General information
Applies to: vehicles with Audi phone box/Audi phone box light
Fig. 123 Front center console: Audi phone box with connections
Depending on vehicle equipment, you may be
able to use
Applies to: vehicles with Audi phone box/Audi phone box light
You can charge your mobile device using a special
USB adapter with the Audi phone box.
Requirement: the ignition must be switched on.
T
SEE MORE:
Removing
- To remove the expanding clips -arrows-,
push the clamping pin -1- carefully
to dimension -x- until it clicks
into the expanding clip -arrow A-.
Dimension -x- = 5 mm
- Pull out unlocked expanding clip -2-
with the clamping pin.
- Remove the lock carrier cove
Removing
- Remove the noise insulation. Refer to
→ Chapter "Overview - Noise Insulation".
- Remove the front bumper cover end plate. Refer to
→ Chapter "Front Bumper Cover End Plate, Removing and
Installing".
- Remove the bolts -arrows-.
- Disconnect the co