Audi Q3: Exterior Equipment
- Overview - Radiator Grille
- Radiator Grille, Removing and Installing
- Spoiler
- Overview - Trim Molding and Covers
- Trim Molding, Removing and Installing
- Wheel Cover, Removing and Installing
- Floor Heat Shield, Removing and Installing
- Noise Insulation
- Underbody Panel
- Roof Bars/Roof Rails
- Roof Railing, Removing and Installing
- Exterior Rearview Mirror
- Wheel Housing Liner
- Name Badges and Emblems
- Trailer Hitch
READ NEXT:
Overview - Radiator Grille
Overview - Radiator Grille, Vehicles through MY 2014
1 - Audi Rings
Removing and installing. Refer to
→ Chapter "Front Emblem, Removing and Installing".
2 - Righ
Radiator Grille, Removing and Installing
Radiator Grille, Removing and Installing, Audi Q3 through MY 2014
Removing
- Remove the bumper cover. Refer to
→ Chapter "Bumper Cover, Removing and Installing".
- Remove the bum
Spoiler
Overview - Spoiler
1 - Left Spoiler
Removing and installing. Refer to
→ Chapter "Rear Window Spoiler, Removing and Installing".
2 - Clip
With foam seal
Qua
SEE MORE:
Using adaptive cruise assist
Applies to: vehicles with adaptive cruise assist
Fig. 99 Lever: using adaptive cruise
assist
Fig. 100 Operating lever: changing the speed
Switching on
To switch on the adaptive cruise assist, pull the
lever up to position 1 until it engages.
Storing the speed and activating regulation
If you
Lock Carrier Cover, Removing and Installing, Vehicles through MY 2014
Removing
- To remove the expanding clips -arrows-,
push the clamping pin -1- carefully
to dimension -x- until it clicks
into the expanding clip -arrow A-.
Dimension -x- = 5 mm
- Pull out unlocked expanding clip -2-
with the clamping pin.
- Remove the lock carrier cove
© 2019-2026 Copyright www.auq3.net
