Audi Q3: Body Exterior
Audi Q3 (8U) 2011-2018 Service Manual / Body Exterior
- General, Technical data
- Body Front
- Hood, Lids
- Front Doors, Central Locking System
- Rear Doors
- Sunroof
- Bumpers
- Glass, Window Regulators
- Exterior Equipment
READ NEXT:
General, Technical data
Repair Information
Wire Routing and Securing
When loosening or removing and installing hydraulic, pneumatic or electrical
lines, draw sketches or take pictures. This will ensure they are installed
Lock Carrier
Overview - Lock Carrier
1 - Lock Carrier
Removing and installing. Refer to
→ Chapter "Lock Carrier, Removing and Installing".
2 - Bolt
4.5 Nm
3 -&nbsSEE MORE:
Drive Axle, Disassembling and Assembling
Drive Axle, Disassembling and Assembling, Drive Axle with 100 mm Inner CV
Joint
Special tools and workshop equipment
required
Tripod Joint Tool -T10065-
Torque Wrench 1331 5-50Nm -VAG1331-
Torque Wrench 1332 40-200Nm -VAG1332-
Clamping Pliers -VAG1682A-
Circlip Pliers -VW161A-
Pre
Repairing a 0.22 mm 2 Wire with Intermediate
Wire Section
Note
For repairing a 0.222 a repair
wire can be used as the intermediate wire with a cross section
of 0.35-mm2 or 0.5-mm2.
Procedure
- Free up the wire to be repaired at two places approximately
20 cm on both sides of the repair point.
Caution
Risk of damaging the
© 2019-2026 Copyright www.auq3.net | 0.0188
