Audi Q3: Hood, Lids
READ NEXT:
Overview - Hood
1 - Hood
A second technician is needed to support and hold the hood during
removal and installation.
Removing:
Unclip and remove the cover -4-.
Engage th
Overview - Latch Release Cable
1 - Right Hood Latch
Removing and installing. Refer to
→ Chapter "Hood Latch, Removing and Installing".
2 - Hood Latch Cable
R
Special tools and workshop equipment
required
Gauge - Gap Adjustment -3371-
Gap Dimensions for Hood
Note
All dimensions are in mm with a +- 0.5 mm tolerance.
Dimension -A- =
SEE MORE:
Fig. 150 Engine compartment - coolant expansion tank (diagram): 1 cover; 2
markings
Observe the safety precautions.
Checking the coolant level
Park the vehicle on a level surface.
Switch the ignition off.
Open the hood.
Check the coolant level in the coolant expansion
tank fig. 146 using th
1 - Lower Clamp
Without hooks
Replace damaged or deformed clips
Insert in the trim panel
Remove any remaining clips in the body mounting points using the
Omega Clip Tool -T40280-. To install, insert into the trim panel.
2 - Center Clamp
with hooks
Replace