Audi Q3: Front Suspension
Chassis / Audi Q3 (8U) 2011-2018 Service Manual / Front Suspension
- Overview - Subframe
- Subframe without Steering Gear, Removing and Installing
- Subframe, Servicing
- Stabilizer Bar, Removing and Installing
- Subframe, Securing
- Suspension Strut and Upper Control Arm
- Overview - Lower Control Arm and Ball Joint
- Lower Control Arm, Removing and Installing
- Ball Joint, Removing and Installing
- Overview - Wheel Bearing
- Wheel Bearing Housing, Removing and Installing
- Wheel Bearing Unit, Removing and Installing
- Overview - Drive Axle
- Drive Axle, Removing and Installing, Drive Axle with Bolted CV Joint VL 107
- Drive Axle, Removing and Installing, Drive Axle with Triple Roller Joint AAR3300i, Mounted on Transmission Stub Shaft
- Drive Axle, Removing and Installing, Left Drive Axle with CV Joint, Inserted with Inner Splines
- Drive Axle, Removing and Installing, Right Drive Axle with CV Joint, Inserted with Inner Splines
- Drive Axle Threaded Connection, Loosening and Tightening
- CV Joint, Servicing, Drive Axle with CV Joint VL107
- CV Joint, Servicing, Drive Axle with Triple Roller Joint AAR3300i, Mounted in Transmission
- CV Joint, Servicing, Drive Axle with Triple Roller Joint AAR3300i, Mounted on Transmission Stub Shaft
- CV Joint, Servicing, Drive Axle with CV Joint, Inserted with Inner Splines
- Outer CV Joint, Checking
- Special Tools
READ NEXT:
Overview - Subframe
Caution
There is a risk of damaging the subframe threaded
connection threads on the body.
The subframe bolts on the body must not be loosened
or tightened with an impact wrench.
A
Subframe without Steering Gear, Removing and Installing
Special tools and workshop equipment
required
Torque Wrench 1331 5-50Nm -VAG1331-
Torque Wrench 1332 40-200Nm -VAG1332-
Engine and Gearbox Jack -VAS6931-
Removing
Note
Subframe
Subframe, Servicing
Special tools and workshop equipment
required
Bearing Installer - Wheel Hub/Bearing Kit -T10205-
Torque Wrench 1332 40-200Nm -VAG1332-
Hydraulic Press -VAS6178-
Pneumatic/Hydraulic Foot PuSEE MORE:
Cooling system
Coolant
The engine cooling system is filled with a mixture
of purified water and coolant additive at the factory.
This coolant must not be not changed.
The coolant level is monitored using the
indicator
light. However, you should occasionally
check the coolant level.
Messages
The following messag
Overview - Brake Booster/Master Brake Cylinder
Note
Brake master cylinder and brake boosters can be replaced
independently of one another.
1 - Heat Shield
2 - Nut
25 Nm
Always replace if removed
Self-locking
3 - Sealing Plug
Coat with brake fluid and press into brake fluid reservo
© 2019-2026 Copyright www.auq3.net | 0.0115
