Audi Q3 Owners & Service Manuals

Audi Q3: Overview - Lower Control Arm and Ball Joint

Suspension, Wheels, Steering / Chassis / Audi Q3 (8U) 2011-2018 Service Manual / Overview - Lower Control Arm and Ball Joint

Audi Q3. Overview - Lower Control Arm and Ball Joint

1 - Control Arm

  • Control arm with mounting bracket, removing and installing. Refer to → Chapter "Lower Control Arm, Removing and Installing".

2 - Bonded Rubber Bushing

  • Replacing. Refer to → Chapter "Lower Control Arm Bonded Rubber Bushing, Replacing".

3 - Bolt

  • 70 Nm + 180º
  • Always replace if removed
  • Tighten only in curb weight position. Refer to → Chapter "Wheel Bearing in Curb Weight, Lifting Vehicles with Coil Spring".

4 - Subframe

5 - Mounting Bracket

  • Securing.

6 - Bolt

  • 70 Nm + 180º
  • Always replace if removed

7 - Bolts

  • 50 Nm + 90º
  • Always replace if removed

8 - Ball Joint

  • Removing and installing. Refer to → Chapter "Ball Joint, Removing and Installing".

9 - Nut

  • 60 Nm
  • Always replace if removed
  • Counterhold at socket head of joint bolt when tightening

10 - Wheel Bearing Housing

  • Removing and installing. Refer to → Chapter "Wheel Bearing Housing, Removing and Installing".

11 - Nut

  • 100 Nm
  • Always replace if removed

READ NEXT:

  Lower Control Arm, Removing and Installing

Special tools and workshop equipment required Locating Pins -T10096- Torque Wrench 1332 40-200Nm -VAG1332- Removing - Before starting work, determine the measurement -a-, for example

  Ball Joint, Removing and Installing

Special tools and workshop equipment required Puller - Ball Joint -3287A- Digital Torque Wrench -VAG1756A- Torque Wrench 1332 Insert - Ring Wrench - 18mm -VAG1332/10- Removing - Loo

  Overview - Wheel Bearing

1 - Suspension Strut 2 - Bolt 70 Nm + 90º Always replace if removed Bolt point must face in direction of travel. 3 - Front Speed Sensor Removing and in

SEE MORE:

  Assisted parking

General information Applies to: vehicles with park assist If your vehicle is equipped with park assist, this system helps you find suitable parking spaces. Parking spaces are measured using ultrasonic sensors on the sides of the vehicle. The system helps you to park while the driver monitors the v

  Anti-Theft Alarm System

Overview - Interior Monitoring 1 - Nut 7 Nm 2 - Bracket For Alarm Horn -H12- 3 - Alarm Horn -H12- Removing and installing. Refer to → Chapter "Alarm Horn -H12-, Removing and Installing". 4 - Connector 5 - Right

© 2019-2026 Copyright www.auq3.net | 0.0103