Audi Q3: Turn signal and high beam lever
.png)
Fig. 38 Operating lever: switching the light functions on
and off
The lever operates the turn signals, the high beams and the headlight flasher.
Turn signals .png)
The turn signal will activate when you move the
lever into a turn signal position while the ignition
is switched on. The respective .png)
or
.png)
indicator
light will flash. The turn signal blinks three times
if you tap the lever (convenience turn signal).
- Right turn signal
- Left turn signal
If an indicator light blinks twice as fast as usual, a turn signal bulb has failed. Carefully drive to an authorized Audi dealer or authorized Audi Service Facility immediately to have the malfunction corrected.
High beams .png)
and headlight
flasher
- Move the lever to the corresponding position:
- High beams on (vehicles with High beam assistant)
- High beams off or headlight flasher
The .png)
indicator light in the
instrument cluster
turns on.
WARNING
High beams can cause glare for other drivers, which increases the risk of an accident. For this reason, only use the high beams or the headlight flasher when they will not create glare for other drivers.
READ NEXT:
High beam assistant
Applies to: vehicles with high beam assistant
The high beam assistant automatically turns the
high beams on or off depending on the surrounding
conditions.
A camera on the rearview mirror mount can d
Adjusting the exterior lighting
The following settings depend on the vehicle
equipment.
Applies to: MMI: Select on the home screen:
VEHICLE > Light & Visibility > Exterior lighting.
Automatic headlights
You can adjust
Interior lighting
Front interior lighting
Fig. 40 Headliner: interior lighting
Interior lighting buttons
- Interior lighting on/off
- Door contact switch on/off.
The interior lighting
is controlled automatically.
TSEE MORE:
Safety Precautions
Start/Stop System Safety Precautions
Pay attention to the following when working on a vehicle
with Stop/Start system:
WARNING
There is a risk of injury if the engine starts
automatically in vehicles with the Start/Stop System.
For vehicles with an activated Start/Stop system
(
Connector Assignments, MMI Navigation Plus
Information Electronics Control Module 1 -J794-
1 - GSM connection from Roof Antenna -R216-
2 - 4-Pin Connector -T4u- to the External Audio Source
Connection -R199-/Internet Access Control Module -J666-
3 - 4-Pin Connector -T4al- to the Front Info