Audi Q3: Bumpers
- Overview - Front Bumper Cover
- Front Bumper Cover, Removing and Installing
- Lock Carrier Cover, Removing and Installing, Vehicles through MY 2014
- Center Grille. Removing and Installing, Audi Q3 Offroad
- Bumper Cover Lower Section, Removing and Installing, Audi Q3
- Molded Foam Part, Removing and Installing, Audi Q3 through MY 2014
- Air Intake Grille Trim, Removing and Installing
- Side Air Intake Trim, Removing and Installing, Audi RS Q3 through MY 2014
- RSQ3 Spoiler-Lower Section, Removing and Installing
- Overview - Rear Bumper Cover
- Rear Bumper Cover, Removing and Installing
- Attachments, Removing and Installing
READ NEXT:
Overview - Bumper Cover, Audi Q3 through MY 2014
1 - Bumper Cover Lower Section
Removing and installing. Refer to
→ Chapter "Bumper Cover Lower Section, Removing and Installi
Bumper Cover, Removing and Installing
Removing
- Remove the front wheel spoiler. Refer to
→ Chapter "Front Wheel Spoiler, Removing and Installing".
- Remove the front wheel housi
Removing
- To remove the expanding clips -arrows-,
push the clamping pin -1- carefully
to dimension -x- until it clicks
into the expanding clip -arrow A-.
Dimension -x- = 5 mm
-&nbs
SEE MORE:
General information
Applies to: vehicles with Audi connect Infotainment and online
radio
You can listen to various radio stations or podcasts
on the Internet using online radio.
Requirement: the MMI must be connected to the
Internet. A data plan must be available.
Accessing online radio through the
Coolant
The engine cooling system is filled with a mixture
of purified water and coolant additive at the factory.
This coolant must not be not changed.
The coolant level is monitored using the
indicator
light. However, you should occasionally
check the coolant level.
Messages
The following messag