Audi Q3: Rear Suspension
- Overview - Subframe
- Subframe, Removing and Installing
- Subframe, Servicing
- Stabilizer Bar
- Overview - Transverse Link
- Upper Transverse Link, Removing and Installing
- Lower Transverse Link, Removing and Installing
- Tie Rod, Removing and Installing
- Suspension Strut/Shock Absorber, Spring
- Overview - Wheel Bearing
- Wheel Bearing Housing, Removing and Installing
- Wheel Bearing Unit, Removing and Installing
- Wheel Bearing Housing Bonded Rubber Bushing, Replacing
- Trailing Arm with Mounting Bracket, Removing and Installing
- Trailing Arm, Servicing
- Overview - Drive Axle
- Drive Axle, Removing and Installing
- Drive Axle, Disassembling and Assembling
- Drive Axle Threaded Connection, Loosening and Tightening
- Special Tools
READ NEXT:
Overview - Subframe, Vehicles with FWD
Caution
There is a risk of damaging the subframe threaded
connection threads on the body.
The subframe bolts on the body must not be loosened
Subframe, Removing and installing, FWD Vehicles
Special tools and workshop equipment
required
Locating Pins -T10096-
Torque Wrench 1332 40-200Nm -VAG1332-
Engine and Gearbox Jack -VAS6931-
Tools and Preliminary Work
Special tools and workshop equipment
required
Hydraulic Press -VAS6178-
with Bearing Installer - Wheel Hub/Bearing Kit - Pressure
Head -T10205/13- from the Bearin
SEE MORE:
Vehicle control modules
Fig. 175 Driver's side footwell: connection port for the On
Board Diagnostic System (BD)
Your vehicle is equipped with electronic control
modules fou various vehicle systems such as the
airbags. These vehicle control modules store data
while driving normally that is required
Steering Column Switch Module, Removing and Installing, with Mechanical
Ignition Lock
Removing
- Adjust steering wheel downward and to rear as far as
possible, use entire adjustment range of steering column
adjustment for this.
- Remove the driver airbag. Refer to
→ Body