Audi Q3: Inner Window Shaft Strip, Removing and Installing
Removing
- Remove the front window frame trim panel. Refer to → Body Interior; Rep. Gr.70; Front Door Trim; Window Frame Trim Removing and Installing.
- Remove the window shaft strip -1- upward -arrows-.
Installing
Install in reverse order of removal. Note the following:
- Place the inner window shaft strip -1- on both ends on the window guide -2--arrow- and press to the center of the door fold.
- Install the front window frame trim panel. Refer to → Body Interior; Rep. Gr.70; Front Door Trim; Window Frame Trim Removing and Installing.
Outer Window Shaft Strip, Removing and Installing
Special tools and workshop equipment required
- Window Slot Seal Tool -T40219-
Window Slot Seal Tool -T40219- preparing:
- To remove the window shaft strip, pull the Window Slot Seal Tool -T40219- carefully at the marked location -arrow- so that it can be inserted behind the strip.
Removing
- Lower the door window.
- Remove the door trim panel. Refer to → Body Interior; Rep. Gr.70; Front Door Panels; Front Door Panel, Removing and Installing.
- Remove the mirror adjustment unit bracket. Refer to → Chapter "Mirror Adjusting Unit Mount, Removing and Installing".
- Remove the inner window shaft strip. Refer to → Chapter "Inner Window Shaft Strip, Removing and Installing".
- Insert the Window Slot Seal Tool -T40219- next to the guide-4- for the window shaft strip -3- and hold it on the strip -2-.
- The front section -1- of the Window Slot Seal Tool -T40219- must be installed as illustrated.
- Push the Window Slot Seal Tool -T40219- gently in direction of -arrow- to release it.
- The retaining strip must audibly unlock.
- Remove the window shaft strip upward from the door flange using the Window Slot Seal Tool -T40219-.
- Remove the window shaft strip.
Installing
Install in reverse order of removal. Note the following:
Note
When installing, the lower edge of the window shaft strip can be coated with tire mounting paste.
- Position the window shaft strip -1- on the B-pillar trim on the door fold and press on it evenly -arrows A-. When doing this, the strip -2- must audibly engage.
- The retaining strip must fit -arrow- under the retaining plate -3-.
- Install the inner window shaft strip. Refer to → Chapter "Inner Window Shaft Strip, Removing and Installing".
- Install the mirror adjustment unit mount. Refer to → Chapter "Mirror Adjusting Unit Mount, Removing and Installing".
READ NEXT:
Door Inner Cover, Removing and Installing
Special tools and workshop equipment
required
Wedge Set -T10383-
Removing
- Remove the door trim panel. Refer to
→ Body Interior; Rep. Gr.70; Front Door Panels; Front
Door Handle, Removing and Installing
Lock Cylinder, Removing and Installing
Removing
- Remove the sealing plugs.
- Remove the clamping screw -3-
until it stops using a screwdriver -4-.
- Press the lock cylinder ret
Door Lock, Removing and Installing
Door Lock, Removing and Installing
Caution
There is a risk of malfunctions.
The door lock must be removed and installed together
with the bracket to prevent over-bending the cable when SEE MORE:
Settings
Wi-Fi
Applies to: vehicles with Wi-Fi hotspot
Depending on the country and the vehicle equipment,
the following functions may be available:
Wi-Fi
When the function is switched on, the MMI's Wi-Fi hotspot is active and Wi-Fi
devices can be connected
to the hotspot.
Wi-Fi hotspot settings
The Wi-Fi c
General information
There may be different media sources and connections
available depending on the vehicle
equipment. For example, you can play media files
using a connected USB drive or connect your mobile
devices to the USB ports with charging function
and operate them through the MMI.
Media and format restrictions