Audi Q3: Interior Lights, Switches
Electrical System / Audi Q3 (8U) 2011-2018 Service Manual / Interior Lights, Switches
- Component Location Overview - Instrument Panel Lamps
- Component Location Overview - Door Ambient Lighting
- Glove Compartment Lamp -W6-, Removing and Installing
- Driver/Front Passenger Door Warning Lamp -W30-/-W36-, Removing and Installing
- Speaker Ambient Lighting Bulb 1 and 2 -L211-/-L212-, Removing and Installing
- Left and Right Ambient Lighting Bulb for Rear Doors -L166-/-L167-, Removing and Installing
- Component Location Overview - Instrument Panel Controls
- Component Location Overview - Center Console Controls
- Light Switch -E1-, Removing and Installing
- Power Window Control Head In Driver Door -E512-, Removing and Installing
- Rear Lid Lock Cylinder Unlock Button -F248-, Removing and Installing
- Anti-Theft Alarm System
- Lane Change Assistance
- Lane Change Assistance, Calibrating
- Driver Assistance Systems Front Camera
- Trailer Hitch
READ NEXT:
Component Location Overview - Instrument Panel Lamps
1 - Center Instrument Panel Vent Illumination Bulb -L68-
integrated in the center instrument panel vent Cannot be replaced
separately if faulty.
Center Instrument Panel Vent, remov
Component Location Overview - Door Ambient Lighting
1 - Storage Compartment Illumination Bulb -L120- in the Front Center
Console
Equipment level
Removing and installing. Refer to
→ Chapter "Storage Compartment Illumination
Glove Compartment Lamp -W6-, Removing and Installing
Removing
- Turn the light switch to position "0".
- Press in the tab -1- using a
flat-head screwdriver and pry out the glove compartment lamp
-2-.
- Disconnect the connector -3-.
SEE MORE:
Level Control System Sensor
Overview - Front Level Control System Sensor
Note
A replacement Left Front Level Control System Sensor -G78- and Right
Front Level Control Sensor -G289- only comes complete with the coupling
rod and the upper and lower retaining plate.
1 - Subframe
2 - Left Fro
Rain/Light Recognition Sensor, Removing and Installing
Rain/Light Recognition Sensor -G397-, Removing and Installing
Special tools and workshop equipment
required
D 009 401 04 -Cleaning Solution-
Removing
- Turn off the ignition.
- Vehicles with ignition lock: Remove the key.
- Remove the interior rearview mirror. Refer to
â
© 2019-2026 Copyright www.auq3.net | 0.0109
