Audi Q3: Front Doors, Central Locking System
Body / Audi Q3 (8U) 2011-2018 Service Manual / Front Doors, Central Locking System
- Overview - Door
- Door, Removing and Installing
- Door, Adjusting
- Inner Door Seal, Removing and Installing
- Overview - Window Regulator
- Window Regulator Motor, Removing and Installing
- Inner Window Shaft Strip, Removing and Installing
- Door Inner Cover, Removing and Installing
- Door Handle, Removing and Installing
- Door Lock, Removing and Installing
- Central Locking
READ NEXT:
Overview - Door
1 - Door
Removing and installing. Refer to
→ Chapter "Door, Removing and Installing".
2 - Bolt
45 Nm
Note
The bolt is a fitting bolt so it is
Door, Removing and Installing
Removing
- Disconnect the door connector on the A-pillar. Refer to
→ Electrical Equipment; Rep. Gr.97; Connectors.
Note
Secure the A-pillar in the area of the door a
Door, Adjusting
Special tools and workshop equipment
required
Gauge - Gap Adjustment -3371-
Door Adjustment Template -T40038 /16-
Check the height adjustment using the Door Adjustment
Template -T40038 /1SEE MORE:
Repair Information
Shock Absorber Leaks
Shock absorbers are frequently rejected and exchanged
because of leaks. Examinations on the test stand and on the
vehicle have shown that the replacement of a large number of
rejected shock absorbers was not justified.
Slight leaking of oil ("sweating") at piston rod sea
Rear Lid Lock Cylinder Unlock Button -F248-, Removing and Installing
Removing
- Remove the rear lid trim panel. Refer to
→ Body Interior; Rep. Gr.70; Luggage Compartment Trim Panels;
Rear Lid Lower Trim Panel, Removing and Installing.
- Disconnect the connectors -2 and 4-
and the antenna wire -1-.
- Free up the wiring harness -
© 2019-2026 Copyright www.auq3.net | 0.0099
