Audi Q3: General, Technical data
Repair Information
Wire Routing and Securing
When loosening or removing and installing hydraulic, pneumatic or electrical lines, draw sketches or take pictures. This will ensure they are installed in their original positions.
Contact Corrosion
Contact corrosion can occur if incorrect fasteners (bolts, nuts, washers, etc.) are used.
For this reason, only fasteners with a special surface coating are installed.
In addition, rubber or plastic parts and adhesives are made of non-conductive materials.
If there are doubts as to whether parts can be reused, use new parts. Refer to the Parts Catalog.
Note
- The use of original replacement parts is recommended, they are tested and are compatible with aluminum.
- The use of Audi accessories is recommended.
- Damage due to contract corrosion is not covered under warranty!
Adhesive Tape Surfaces
- The vehicle must be at room temperature before the installation of self-adhesive cover, door seal molding, etc. when using adhesive tape.
- The adhesive surfaces on the body must be free of dirt and grease.
- Clean the adhesive surfaces using Cleaning Solution -D 009 401 04-.
- Apply Bonding Agent -D 355 205 A2- on the surface on the body side using the Applicator -D 009 500 25- and let dry.
- Warm the adhesive areas to approximately 40 ℃ (104 ºF) using a hot air blower.
- After installing the covers with adhesive tape, use a roller and press the adhesive tape one more time to make sure it is on securely.
- After that, pull on the adhesive tape by hand just to make sure it is on.
Secured Bolted Connections
Bolts secured by a "microencapsulated screw" must be replaced, and the threaded holes must be cleaned with a corresponding thread tap.
READ NEXT:
Lock Carrier
Overview - Lock Carrier
1 - Lock Carrier
Removing and installing. Refer to
→ Chapter "Lock Carrier, Removing and Installing".
2 - Bolt
4.5 Nm
3 -&nbs
Fender
Overview - Fender
1 - Bolt
8 Nm
Quantity: 2
2 - Lower bracket
For the fender
Removing and installing. Refer to
→ Chapter "Fender, Removing and InstallingSEE MORE:
Tires and vehicle load limits
There are limits to the amount of
load or weight that any vehicle
and any tire can carry. A vehicle
that is overloaded will not handle
well and is more difficult to stop.
Overloading can not only lead to
loss of vehicle control, but can also
damage important parts of the
vehicle and can lead to sud
Inner Door Seal, Removing and Installing
Removing
- Remove the rear sill panel strip. Refer to
→ Body Interior; Rep. Gr.70; Passenger Compartment Trim; Sill
Panel Strip, Removing and Installing.
- Remove the upper and lower B-pillar trim. Refer to
→ Body Interior; Rep. Gr.70; Passenger Comp