Audi Q3: Front Doors, Central Locking System
Body / Audi Q3 (8U) 2011-2018 Service Manual / Front Doors, Central Locking System
- Overview - Door
- Door, Removing and Installing
- Door, Adjusting
- Inner Door Seal, Removing and Installing
- Overview - Window Regulator
- Window Regulator Motor, Removing and Installing
- Inner Window Shaft Strip, Removing and Installing
- Door Inner Cover, Removing and Installing
- Door Handle, Removing and Installing
- Door Lock, Removing and Installing
- Central Locking
READ NEXT:
Overview - Door
1 - Door
Removing and installing. Refer to
→ Chapter "Door, Removing and Installing".
2 - Bolt
45 Nm
Note
The bolt is a fitting bolt so it is
Door, Removing and Installing
Removing
- Disconnect the door connector on the A-pillar. Refer to
→ Electrical Equipment; Rep. Gr.97; Connectors.
Note
Secure the A-pillar in the area of the door a
Door, Adjusting
Special tools and workshop equipment
required
Gauge - Gap Adjustment -3371-
Door Adjustment Template -T40038 /16-
Check the height adjustment using the Door Adjustment
Template -T40038 /1SEE MORE:
Fastening and unfastening safety belts
Fig. 60 Belt buckle and belt latch
Fig. 61 Releasing the belt buckle from the belt latch
Fastening the safety belt
Pull the safety belt by the belt buckle evenly
across your chest and lap.
Insert the belt buckle in the belt latch belonging
to the seat until it audibly engages
fig. 60.
Pull
Emissions control system
General information
WARNING
The temperature of the exhaust system is
high, both when driving and after stopping
the engine.
Never touch the exhaust tail pipes once they
have become hot. This could result in burns.
Do not park your vehicle over flammable
materials such as grass or leaves because
© 2019-2026 Copyright www.auq3.net | 0.0095
