Audi Q3: Hood, Lids
Body / Audi Q3 (8U) 2011-2018 Service Manual / Hood, Lids
- Overview - Hood
- Overview - Release Cable
- Hood, Adjusting
- Release Cable, Removing and Installing
- Hinges, Removing and Installing
- Overview - Rear Lid
- Rear Lid, Removing and Installing
- Actuator, Removing and Installing
- Rear Lid Seal, Removing and Installing
- Fuel Filler Door Unit
READ NEXT:
Overview - Hood
Overview - Hood
1 - Hood
A second technician is needed to support and hold the hood during
removal and installation.
Removing:
Unclip and remove the cover -4-.
Engage th
Overview - Release Cable
Overview - Latch Release Cable
1 - Right Hood Latch
Removing and installing. Refer to
→ Chapter "Hood Latch, Removing and Installing".
2 - Hood Latch Cable
R
Hood, Adjusting
Special tools and workshop equipment
required
Gauge - Gap Adjustment -3371-
Gap Dimensions for Hood
Note
All dimensions are in mm with a +- 0.5 mm tolerance.
Dimension -A- = SEE MORE:
Rear Lid, Removing and Installing
Rear Lid, Removing and Installing
A second technician will be needed during removal and
installation to support and to hold the rear lid.
Removing:
Note
Mark the position of the rear lid on the rear lid hinge with
a felt-tip pen before removing.
- Remove the rear lid trim
Lane Change Assistance
Overview - Lane Change Assistance
1 - Lane Change Assistance Button -E530-
Removing and installing. Refer to
→ Chapter "Lane Change Assistance Button -E530-, Removing and
Installing".
2 - Lane Change Assistance Warning Lamp In Driver Exterior Rearview
Mirro
© 2019-2026 Copyright www.auq3.net | 0.0092
