Audi Q3: Sunroof
Body / Audi Q3 (8U) 2011-2018 Service Manual / Sunroof
- Overview - Sunroof
- Sunroof Frame, Removing and Installing
- Glass Panel, Removing and Installing
- Sunroof Seals, Removing and Installing
- Water Drain Hoses
READ NEXT:
Overview - Sunroof
1 - Panorama Roof Frame
Removing. Refer to
→ Chapter "Sunroof Frame, Removing and Installing".
2 - Seal
Open the panel "1" completely and remove
the seal.
Sunroof Frame, Removing and Installing
1 - Bolt
3 Nm
2 - Power Sunroof Control Module -J245-.
Performing the adaptation procedure. Refer to
→ Chapter "Motor Adaptation".
3 - Bolt
Glass Panel, Removing and Installing
Panel 1 for the Panorama Roof, Removing
Caution
Do not move or operate the already removed panel
otherwise it may become damaged.
Note
If the screws for the panel mounting werSEE MORE:
Cup holders
Applies to: vehicles with cup holders
Fig. 69 Front center console: cup holders
Fig. 70 Rear center armrest: cup holders
Cup holders in the front center console
Set your beverage in the holder 1.
Cup holders in the rear center armrest
Fold the center armrest downward.
To open the cup holder,
Chip Card Reader Control Module, Removing and Installing
The Chip Card Reader Control Module -J676--1-
is located inside the glove compartment
-2-.
Removing
- Turn off the ignition and all electrical equipment and
remove the ignition key.
- Remove the glove compartment. Refer to
→ Body Interior; Rep. Gr.68; Storage Co
© 2019-2026 Copyright www.auq3.net | 0.0093
