Audi Q3: Rear Doors
Body / Audi Q3 (8U) 2011-2018 Service Manual / Rear Doors
- Overview - Door
- Door, Removing and Installing
- Door, Adjusting
- Inner Door Seal, Removing and Installing
- Overview - Window Regulator
- Overview - Door Handle and Door Lock
- Window Regulator Motor, Removing and Installing
- Inner Window Shaft Strip, Removing and Installing
- Door Handle, Removing and Installing
- Door Lock, Removing and Installing
READ NEXT:
Overview - Door
1 - Door
Removing and installing. Refer to
→ Chapter "Door, Removing and Installing".
2 - Bolt
45 Nm
Note
The bolt is a fitting bolt so it is
Door, Removing and Installing
Removing
- Disconnect the door connector from the B-pillar. Refer to
→ Electrical Equipment; Rep. Gr.97; Connectors.
Note
Secure the B-pillar in the area of the door
Door, Adjusting
Special tools and workshop equipment
required
Gauge - Gap Adjustment -3371-
Door Adjustment Template -T40038 /16-
Check the Height Adjustment using the Door Adjustment
Template -T40038 /1SEE MORE:
General information
Regular, proper care helps to maintain your vehicle's
value. It can also be a requirement when
submitting warranty claims for corrosion damage
and paint defects on the body.
The required cleaning and care products can be
obtained from an authorized Audi dealer or authorized
Service Facility. Read a
Window Regulator Motor, Removing and Installing
Removing
Note
The window regulator motor can be removed or installed with
the motor or door window in any position.
- Remove the rear door trim panel. Refer to
→ Body Interior; Rep. Gr.70; Rear Door Trim Panels; Rear Door
Trim Panel, Removing and Installing.
-
© 2019-2026 Copyright www.auq3.net | 0.0156
