Audi Q3: Mechanical Components
Chassis / Audi Q3 (8U) 2011-2018 Service Manual / Mechanical Components
- Overview - Front Brakes
- Front Brake Caliper Balance Weight
- Front Brake Pads, Removing and Installing
- Front Brake Caliper, Removing and Installing
- Front Brake Caliper, Replacing
- Front Brake Rotor, Removing and Installing
- Overview - Rear Brakes
- Rear Brake Pads, Removing and Installing
- Rear Brake Caliper, Removing and Installing
- Rear Brake Caliper, Replacing
- Rear Brake Rotor, Removing and Installing
- Parking Brake
- Brake Pedal
READ NEXT:
Overview - Front Brakes
Overview - Front Brakes, 1LJ 1ZD Brakes
1 - Bolt
12 Nm
2 - Brake Rotor
Allocation, refer to the Parts Catalog.
Dimensions, refer to
→ Chapter "Brakes
Front Brake Caliper Balance Weight
Depending on the model for each brake caliper two vibration
dampers are installed.
1 - Bolt
10 Nm
Replace after each removal.
2 - Vibration Damper
Installed 2 on
Front Brake Pads, Removing and Installing
Brake Pads, Removing and Installing, 1LJ, 1ZD Brakes
If old brake pads are being replaced with new ones, then it is necessary
to check the brake rotor thickness for wear. Pay attention to the wear SEE MORE:
Privacy notice
You can find information about responsibility for
data protection in the MMI.
Applies to: MMI: Select on the home screen: SETTINGS
> General > Legal notes > About Audi
connect.
Image recording
Surrounding area monitoring
Applies to: vehicles with surrounding area monitoring
Some vehicle fu
Molded Foam Part, Removing and Installing, Audi Q3 through MY 2014
Removing
- Remove the front bumper cover. Refer to
→ Chapter "Bumper Cover, Removing and Installing".
- Guide the molded foam piece -2-
at the top out of the bracket -arrow-
and at the bottom out of the holder -1-.
Installing
Install in reverse order of removal. Note the f
© 2019-2026 Copyright www.auq3.net | 0.0173
