Audi Q3: Interior Lights, Switches
Electrical System / Audi Q3 (8U) 2011-2018 Service Manual / Interior Lights, Switches
- Component Location Overview - Instrument Panel Lamps
- Component Location Overview - Door Ambient Lighting
- Glove Compartment Lamp -W6-, Removing and Installing
- Driver/Front Passenger Door Warning Lamp -W30-/-W36-, Removing and Installing
- Speaker Ambient Lighting Bulb 1 and 2 -L211-/-L212-, Removing and Installing
- Left and Right Ambient Lighting Bulb for Rear Doors -L166-/-L167-, Removing and Installing
- Component Location Overview - Instrument Panel Controls
- Component Location Overview - Center Console Controls
- Light Switch -E1-, Removing and Installing
- Power Window Control Head In Driver Door -E512-, Removing and Installing
- Rear Lid Lock Cylinder Unlock Button -F248-, Removing and Installing
- Anti-Theft Alarm System
- Lane Change Assistance
- Lane Change Assistance, Calibrating
- Driver Assistance Systems Front Camera
- Trailer Hitch
READ NEXT:
Component Location Overview - Instrument Panel Lamps
1 - Center Instrument Panel Vent Illumination Bulb -L68-
integrated in the center instrument panel vent Cannot be replaced
separately if faulty.
Center Instrument Panel Vent, remov
Component Location Overview - Door Ambient Lighting
1 - Storage Compartment Illumination Bulb -L120- in the Front Center
Console
Equipment level
Removing and installing. Refer to
→ Chapter "Storage Compartment Illumination
Glove Compartment Lamp -W6-, Removing and Installing
Removing
- Turn the light switch to position "0".
- Press in the tab -1- using a
flat-head screwdriver and pry out the glove compartment lamp
-2-.
- Disconnect the connector -3-.
SEE MORE:
Refueling
Messages
The following messages may appear depending
on the vehicle equipment:
Messages
If the indicator light appears
with a corresponding
message, refuel the vehicle.
Tank system: malfunction!
Please contact
Service
There is a malfunction in the fuel tank system.
Drive to an authorized Audi d
Front Exterior Door Handle Switch, Removing and Installing
Removing
- Remove the exterior door handle. Refer to
→ Body Exterior; Rep. Gr.57; Door Components; Door Handle,
Removing and Installing.
Note
Ignore -1 and 2-.
- Release the retaining tabs in direction of
-A arrows- and remove the connector
-3-.
- C
© 2019-2026 Copyright www.auq3.net | 0.01
