Audi Q3: Door, Removing and Installing
Removing
- Disconnect the door connector on the A-pillar. Refer to → Electrical Equipment; Rep. Gr.97; Connectors.
Note
Secure the A-pillar in the area of the door arrester using adhesive tape, so that the paint will not be damaged.
- Remove the door arrester bolt -2-.
- Remove the cover caps -1- and -3- from the stud bolts.
- Remove the stud bolts -4- on the upper and lower door hinge.
Caution
There is a risk of damaging the paint.
Protect the painted surfaces on the door or on the side panel from damage.
- Carefully remove the door upward out of the door hinges.
Installing
- Gap dimensions.
- Tightening specification: Refer to → Chapter "Overview - Door".
Install in reverse order of removal. Note the following:
Note
Do not make any adjustments after installing the door.
Door Arrester, Removing and Installing
Removing
Note
Secure the A-pillar in the area of the door arrester using adhesive tape, so that the paint will not be damaged.
- Move the door window into the "closed" position.
- Remove the door trim panel. Refer to → Body Interior; Rep. Gr.70; Front Door Panels; Front Door Panel, Removing and Installing.
- Remove the lower speaker. Refer to → Communication; Rep. Gr.91; Component Location Overview - Sound System.
- Remove the door arrester bolt -arrow-.
- If equipped, remove the door arrester cover -1- from the door opening.
- Remove the bolt -arrows- and remove the door arrester -2- inward.
- Pull the rubber grommet -1- on the door arrester to the side slightly -A arrows-.
- Remove the rubber grommet from the door arrester -2--arrow B-.
Installing
Install in reverse order of removal. Note the following:
- Push the rubber seal on the door arrester, while doing so pay attention to the allocation of the rubber seal.
- The name badge for the left or right side must be readable at the top.
- Install the lower speaker. Refer to → Communication; Rep. Gr.91; Component Location Overview - Sound System.
- Install the door trim panel. Refer to → Body Interior; Rep. Gr.70; Front Door Trim Panels; Front Door Trim Panel, Removing and Installing.
READ NEXT:
Door, Adjusting
Special tools and workshop equipment
required
Gauge - Gap Adjustment -3371-
Door Adjustment Template -T40038 /16-
Check the height adjustment using the Door Adjustment
Template -T40038 /1
Inner Door Seal, Removing and Installing
Removing
- Remove the upper A-pillar trim. Refer to
→ Body Interior; Rep. Gr.70; Passenger Compartment Trim;
A-Pillar Trim, Removing and Installing.
- Remove the front
Overview - Window Regulator
1 - Door
2 - Clip
For the window regulator cable
3 - Lower Double-Bolt
4 - Window Regulator
Removing and installing. Refer to
→ Chapter SEE MORE:
Service interval display
The service interval display detects when your vehicle
is due for service.
The service interval display works in two stages:
Inspection or oil change reminder: after driving
a certain distance, a message will appear in
the instrument cluster display each time the ignition
is switched on or off,
Wheel Housing Liner
Overview - Front Wheel Housing Liner
1 - Front Wheel Spoiler
Removing and installing. Refer to
→ Chapter "Front Wheel Spoiler, Removing and Installing".
2 - Bolt
2.5 Nm
3 - Metal Nut
4 - Spring Nut
For the quick release
Quantit