Audi Q3 Owners & Service Manuals

Audi Q3: Wheel and Tire General Information

Audi Q3 (8U) 2011-2018 Service Manual / Wheel and Tire General Information

READ NEXT:

  Specifications for Retrofitting Wheel and Tire Combinations (Documents)

Legal Requirements The manufacturer is granted general type approval for the whole vehicle including all parts and for specific retrofitting (general type approval according to 20 StVZO (Motor V

  Wheel Bolt Tightening Specifications

Wheel Bolt Tightening Specifications, Current Models DANGER! To ensure that the wheel bolts fit correctly, be sure to use the correct wheel bolts specified for the model. The wheel bolts for eac

  Acceptable Tread Depth Variance

Model with Longitudinally Installed Engine Tread variance for models with a longitudinally installed engine, such as A4, A5, A6, A7, A8, Q5, Q7, ... The variance between the front and rear axle in

SEE MORE:

  Overview - Rear Outer Three-Point Seat Belt

1 - Belt Guide   Caution Do not rotate bolts under any circumstances when removing and installing belt guide. They are set by the manufacturer. Replace the entire belt guide if damaged. Removing and installing. Refer to → Chapter "Rear Seat Belt Guide, Rem

  Heater and A/C Unit, Removing and Installing

Special tools and workshop equipment required Hose Clamps - Up To 25mm -3094- Engine Bung Set -VAS6122- Compressed air gun, commercially available Removing   WARNING There is a risk of scalding from hot steam and coolant. The coolant system is under pressure when the eng

© 2019-2026 Copyright www.auq3.net | 0.0102