Audi Q3: Tire Requirement and Maintenance
Chassis / Audi Q3 (8U) 2011-2018 Service Manual / Tire Requirement and Maintenance
- Introduction
- Tire Requirements
- Tread Depth, Measuring
- Rubber Valve
- Light Alloy Wheels, Care and Maintenance
READ NEXT:
Introduction
This revised information should supplement the knowledge and
experience you already have.
With this information, we want to help you make as clear and
certain a statement as possible concerning t
Tire Requirements
A - Wet braking behavior
B - Comfort
C - Steering precision
D - Driving stability
E - Tire weight
F - Service life expectancy
G
Tread Depth, Measuring
Tread Depth, Measuring
Note
When measuring tread depth, take measurements in the main
grooves.
Do not measure on the TWI (tread wear indicator).
Tread depth of a tire must be measSEE MORE:
Actuator, Removing and Installing
Rear Lid Motor 1 and 2 -V444-/-V445-, Removing and Installing
WARNING
After removing and installing, the Rear Lid Motor 1
- V444- or Rear Lid Motor 2 -V445- must be adapted via
Guided Functions using the Vehicle Diagnostic Tester
→ Vehicle diagnostic tester.
Removing
-
Bumper Cover Lower Section, Removing and Installing, Audi Q3
Removing
- Remove the front bumper cover. Refer to
→ Chapter "Bumper Cover, Removing and Installing".
- Remove the front bumper cover end plate. Refer to
→ Chapter "Front Bumper Cover End Plate, Removing and
Installing".
- If equipped, disconnect the connector
© 2019-2026 Copyright www.auq3.net | 0.0117
