Audi Q3: Wheels/Tires/Tire Pressure Monitoring Assembly
Chassis / Audi Q3 (8U) 2011-2018 Service Manual / Wheels/Tires/Tire Pressure Monitoring Assembly
- Wheels and Tires, General Information
- Component Overview - Run-Flat Tire (PAX)
- Wheel, Changing and Mounting
- Installation Instructions, Run-Flat Tires
- Removing Tires, Run-Flat Tires
- Tires, Mounting, Run-Flat Tires
- Tires, Changing
READ NEXT:
Wheels and Tires, General Information
Only install tires with the same manufacturer, construction
type and tread on all wheels.
Always replace rubber valve when replacing steel wheel or
rim.
Install tires with DOT identification fac
Component Overview - Run-Flat Tire (PAX)
Caution
It is mandatory for run-flat tires to have a tire
pressure monitoring system in the vehicle.
Note
Be careful not to scratch off the glued- on wheel trim on
these r
Wheel, Changing and Mounting
Special tools and workshop equipment
required
Torque Wrench 1332 40-200Nm -VAG1332-
Wheel Lock Set -T10101-
Wheel Lock Set -T10101A-
Wheel Lock Set -T40004-
Wheel Lock Set -T40073-
WaxSEE MORE:
Additional safety belt functions
Belt retractor lock
The safety belts on the rear seats and on the
front passenger seat are equipped with a belt retractor
lock.
If you secure a child safety seat with a safety
belt, the belt retractor lock on the safety belt
may need to be activated. Follow the instructions
from the child safet
Side Air Intake Trim, Removing and Installing, Audi RS Q3 through MY 2014
Removing
- Left: remove the front bumper cover. Refer to
→ Chapter "Bumper Cover, Removing and Installing".
- Right: remove the front wheel housing liner and wheel
spoiler. Refer to
→ Chapter "Front Wheel Housing Liner, Removing and Installing".
- Carefully remov
© 2019-2026 Copyright www.auq3.net | 0.0123
