Audi Q3: Balancing
Chassis / Audi Q3 (8U) 2011-2018 Service Manual / Balancing
READ NEXT:
General Information
Before beginning balancing, the following requirements must
be fulfilled.
Tire inflation pressure must be OK.
The tire tread must not be worn down on one side and should
be at least 4 mm dee
Finish Balancer
Caution
For the balancing, the wheels of the tractive axle
are set upon the turntable sensors, for example, front
wheels for Front Wheel Drive (FWD) and all 4 wheels for
All Wheel Dri
Vehicle Pulls to One Side
General Information
Perform a road test to determine if a vehicle pulls to one
side and if so, when and to which side. If the vehicle pulls to
one side, see procedure
→ Chapter "CorrectiSEE MORE:
Tire wear and damage
Fig. 155 Tire profile: treadwear indicator
Tire wear
Check the tires regularly for wear.
Inflation pressure that is too low
or high can increase tire wear
considerably.
Driving quickly through curves,
rapid acceleration, and heavy
braking increase tire wear.
Have an authorized Audi dealer
Special Tools
Special tools and workshop equipment
required
Piston Resetting Tool -T10145-
Piston Resetting Tool - Cap /6 -T10146/6- from Piston
Resetting Tool - Caps /1,/2,/3,/4,/5 -T10146-
Brake Pressure Gauge -VAG1310A-
Brake Pedal Actuator -VAG1869/2-.
Brake Line Tool K
© 2019-2026 Copyright www.auq3.net | 0.009
