Audi Q3: Wheel Bolts
Chassis / Audi Q3 (8U) 2011-2018 Service Manual / Wheel Bolts
Wheel Bolt Types
Note
Make sure the correct wheel bolts are installed. Refer to the Parts Catalog.
Standard, One-Piece Wheel Bolt
Two-piece wheel bolt, short turnable spherical calotte, primarily for S models.
Two-piece wheel bolt, short turnable spherical calotte, primarily for S models.
Anti-Theft Wheel Bolts
1 - Anti-theft wheel bolts
2 - Cap
3 - Wheel bolt adapter
Master Sets for Anti-Theft Wheel Bolts
Special tools and workshop equipment required
- Torque Wrench 1332 40-200Nm -VAG1332-
- Wheel Lock Set -T10101-
- Wheel Lock Set -T10101A-
- Wheel Lock Set -T40004-
- Wheel Lock Set -T40073-
READ NEXT:
Wheels and Tires, General Information
Only install tires with the same manufacturer, construction
type and tread on all wheels.
Always replace rubber valve when replacing steel wheel or
rim.
Install tires with DOT identification fac
Component Overview - Run-Flat Tire (PAX)
Caution
It is mandatory for run-flat tires to have a tire
pressure monitoring system in the vehicle.
Note
Be careful not to scratch off the glued- on wheel trim on
these rSEE MORE:
Front Three-Point Seat Belt, Removing and Installing
Front Three-Point Seat Belt, Removing and Installing
Removing
WARNING
Follow all safety precautions when working with
pyrotechnic components. Refer to
→ Chapter "Pyrotechnic Components Safety Precautions".
Follow all regulations when disposing of pyrotechnic
components
General Information
Before beginning balancing, the following requirements must
be fulfilled.
Tire inflation pressure must be OK.
The tire tread must not be worn down on one side and should
be at least 4 mm deep.
The tire must not have any flat spots.
It is not possible to balance a flat spot.
The ti
© 2019-2026 Copyright www.auq3.net | 0.0115
