Audi Q3: Passenger Protection, Airbags, Seat Belts
Body / Audi Q3 (8U) 2011-2018 Service Manual / Passenger Protection, Airbags, Seat Belts
- Component Location Overview - Seat Belts and Attaching Points
- Overview - Front Three-Point Seat Belt
- Overview - Rear Outer Three-Point Seat Belt
- Front Three-Point Seat Belt, Removing and Installing
- Rear Three-Point Seat Belt, Removing and Installing
- Front Belt End Fitting, Removing and Installing
- Child Seat Anchors
- Airbag System
- Airbag Control Module
- Battery Interrupt Igniter
- Driver Side Airbag
- Front Passenger Airbag
- Side Airbags
- Head Curtain Airbags
- Component Location Overview - Airbag Crash Sensors
- Driver Front Airbag Crash Sensor -G283-, Removing and Installing
- Driver Side Airbag Crash Sensor -G179-/ Front Passenger Side Airbag Crash Sensor -G180-, Removing and Installing
- Seat Position Sensor
- Belt Fastening Detection
- Passenger Occupant Detection System
- Deformation Element
READ NEXT:
Component Location Overview - Seat Belts and Attaching Points
1 - Front Seat Belt Latch
Overview. Refer to
→ Chapter "Overview - Front Seat Belt Latch".
2 - Front Passenger Seat Belt Tensioner Igniter 2 -N298-
Only USA a
Overview - Front Three-Point Seat Belt
Overview - Front Three-Point Seat Belt, USA and Canada Market
1 - Belt End Fitting Cover
Removing and installing. Refer to
→ Chapter "Front Belt End Fitting, Removing and Ins
Overview - Rear Outer Three-Point Seat Belt
1 - Belt Guide
Caution
Do not rotate bolts under any circumstances when removing
and installing belt guide. They are set by the manufacturer.
Replace the entire belt guiSEE MORE:
Glass Panel, Removing and Installing
Panel 1 for the Panorama Roof, Removing
Caution
Do not move or operate the already removed panel
otherwise it may become damaged.
Note
If the screws for the panel mounting were completely
removed, then they must be replaced.
1 - Bolt
7 Nm
Front and rear,
Cover and Cushion, Removing and Installing
Cover and Cushion, Removing and Installing, Bench Seat
Removing
- Remove the rear bench seat. Refer to
→ Chapter "Bench Seat/Single Seat, Removing and Installing".
- Pry up the seat cover clamping strip
-2- with a screwdriver along the seat frame from the
molded part.
-&nb
© 2019-2026 Copyright www.auq3.net | 0.0115
