Audi Q3: Checking and Filling
Audi Q3 (F3) 2018-2026 Owner's Manual / Maintenance and Care / Checking and Filling
- Fuel
- Refueling
- Emissions control system
- Engine compartment
- Opening and closing the hood
- Engine oil
- Checking the engine oil level
- Adding engine oil
- Changing engine oil
- Cooling system
- Checking coolant
- Brake fluid
- Electrical system
- Battery
- Safety precautions
- Charging the 12 volt vehicle battery
- Windshield washer system
- Service interval display
READ NEXT:
Fuel
Types of gasoline
The correct gasoline grade is stated on the inside
of the fuel filler door.
The vehicle is equipped with a catalytic converter
and must only be driven with unleaded gasoline.
Audi r
Refueling
Messages
The following messages may appear depending
on the vehicle equipment:
Messages
If the indicator light appears
with a corresponding
message, refuel the vehicle.
Tank system: malfunction!
P
Emissions control system
General information
WARNING
The temperature of the exhaust system is
high, both when driving and after stopping
the engine.
Never touch the exhaust tail pipes once they
have become hot. This could
SEE MORE:
Rear Brake Rotor, Removing and Installing
Brake Rotor, Removing and Installing, Brake 1KU
Removing
- Remove the brake caliper with brake carrier, refer to
→ Chapter "Brake Caliper, Removing and Installing, Brake 1KU".
- Remove bolt -3- and remove the
brake rotor.
Installing
Install in reverse order of removal. Not
Expansion Valve, Removing and Installing
Special tools and workshop equipment
required
Engine Bung Set -VAS6122-
Removing
- Remove the refrigerant pipes from the expansion valve. Refer
to
→ Chapter "Refrigerant Lines, Disconnecting and Connecting at
Expansion Valve".
- Remove the bolts -A-.
- Remove
© 2019-2026 Copyright www.auq3.net
