Audi Q3 Owners & Service Manuals

Audi Q3: Safety precautions

Explanation of warning symbols:

Observe all warnings - there is a risk for injury!

Always follow the instructions in the operating manual.

Electrolyte fluid is highly corrosive. Always wear protective gloves and eye protection.

First aid: if electrolyte fluid enters the eyes, immediately flush with clean water for several minutes. Seek medical attention immediately. Immediately neutralize electrolyte fluid on the skin or clothing using a soap solution and rinse with plenty of water. If electrolyte fluid is accidentally ingested, seek medical attention immediately.

Always wear eye protection.

If electrolyte fluid enters the eyes, immediately flush with clean water for several minutes. Seek medical attention immediately.

Fire, sparks, open flame are prohibited. Avoid creation of sparks and short circuits when handling cables and electrical devices.

Always keep children away from battery electrolyte fluid and the battery.

A highly explosive mixture of gases can form when charging batteries.

WARNING

All work on the batteries must only be performed by an authorized Audi dealer or authorized Audi Service Facility.

  • Gases that escape from these batteries can be poisonous or flammable.
  • The contents of these batteries can be corrosive.

    If any battery contents come into contact with the skin, flush the affected area for at least 15 minutes with clean water. Then wash the affected area with soap. Have the affected area examined by a medical professional.

    READ NEXT:

     Charging the 12 volt vehicle battery

    Fig. 152 Engine compartment with battery: connections for charger and jump start cable Observe the safety precautions. Requirement: only use chargers with a maximum charging current of 14.8 volts. Th

     Windshield washer system

    Fig. 153 Engine compartment: washer fluid reservoir cap Observe the safety precautions. The windshield washer reservoir contains the cleaning solution for the windshield/rear window and the headli

     Service interval display

    The service interval display detects when your vehicle is due for service. The service interval display works in two stages: Inspection or oil change reminder: after driving a certain distance, a m

    SEE MORE:

     Front Brake Caliper Balance Weight

    Depending on the model for each brake caliper two vibration dampers are installed. 1 - Bolt 10 Nm Replace after each removal. 2 - Vibration Damper Installed 2 on each brake caliper Removing and installing, refer to → Chapter "Damper, Removing and Inst

     Lane Change Assistance, Calibrating

    Special tools and workshop equipment required Calibration Tool -VAS6350- Conditions - The Lane Change Assistance Control Module -J769-/ Lane Change Assistance Control Module 2 -J770- must be calibrated using the Vehicle Diagnostic Tester during the following conditions: Lane

    © 2019-2025 Copyright www.auq3.net