Audi Q3: Electrical Equipment
Audi Q3 (8U) 2011-2018 Service Manual / Electrical Equipment
- General, Technical data
- Battery, Starter, Generator, Cruise Control
- Instruments
- Windshield Wiper/Washer System
- Exterior Lights, Switches
- Interior Lights, Switches
- Wiring
READ NEXT:
General, Technical data
Safety Precautions
Start/Stop System Safety Precautions
When Working on Vehicles with the Start/Stop System, Observe
the Following:
WARNING
Danger of personal injury because the engine
Overview - Battery
Overview - Battery, Engine Compartment Battery Version 1
1 - Battery Tray
Removing and installing. Refer to
→ Chapter "Battery Tray, Removing and Installing, Version 1".
2SEE MORE:
Tire pressure
Fig. 156 Driver's side B-pillar: tire pressure
label
Fig. 157 Tire pressure label
The correct tire pressure for tires
installed at the factory is listed on
a label. The label is located on the
B-pillar (driver's side) fig. 156,
fig. 157.
Use the tire pressure specified for
a normal vehicle load
Instrument Panel Central Tube
Overview - Instrument Panel Central Tube
1 - Bolt
20 Nm
2 - Nut
23 Nm
Quantity: 2
Always replace if removed
3 - Threaded Pin
20 Nm
Quantity: 2
4 - Balancing Element
Clip in on the central tube
Check the balanc
© 2019-2026 Copyright www.auq3.net | 0.0102
