Audi Q3: Instruments
Electrical System / Audi Q3 (8U) 2011-2018 Service Manual / Instruments
READ NEXT:
Instrument Cluster
Overview - Instrument Cluster
1 - Outside Air Temperature Sensor -G17-
Removing and installing. Refer to
→ Chapter "Outside Air Temperature Sensor, Removing and Installing".
Fuel Level Sensor Connector Assignment
Fuel Level Sensor -G- Connector Assignment
Disconnect the connector on the fuel tank locking flange.
For the procedure. Refer to
→ Rep. Gr.20; Fuel Delivery Unit/Fuel Level Sensor; Fu
Horn
Overview - Horn
1 - Nut
9 Nm
2 - Nut
9 Nm
3 - Low Tone Horn -H7-
Removing and installing. Refer to
→ Chapter "High Tone Horn -H2-/Low Tone HSEE MORE:
Lock Cylinder, Removing and Installing
Create an assisting tool from a wire hook as follows:
- Take a 1.5 mm diameter welding wire and bend the end to form
an eye.
- Then cut the welding wire.
Dimension -a- = approximately
50 mm.
- File the end of the wire hook into a point.
Dimension -b- = 3 mm
Vehicle Electrical System, General Repair Information
Caution
When disconnecting and connecting battery, the
procedure must be followed as described in the Repair
Manual.
WARNING
Some tools are supplied with a tool safety clip,
which is slid over the tool points after using the tool,
in order to protect other workers from
© 2019-2026 Copyright www.auq3.net | 0.0109
