Audi Q3: Windshield Wiper/Washer System
Electrical System / Audi Q3 (8U) 2011-2018 Service Manual / Windshield Wiper/Washer System
- Windshield Wiper System
- Windshield Wiper Arms, Removing and Installing
- Rain/Light Recognition Sensor, Removing and Installing
- Windshield Washer System
- Rear Window Wiper System
- Rear Window Washer System
- Headlamp Washer System
READ NEXT:
Windshield Wiper System
Overview - Windshield Wiper System
Overview - Windshield Wiper System
1 - Bolt
Tightening sequence. Refer to → Fig. " Windshield Wiper
Motor -V- - Tightening Specification
Windshield Wiper Arms, Removing and Installing
Special tools and workshop equipment
required
Puller - Wiper Arm Kit -T10369-
Removing
Note
If the windshield wiper motor is to be run during the work
procedure, the hood must be
Rain/Light Recognition Sensor, Removing and Installing
Rain/Light Recognition Sensor -G397-, Removing and Installing
Special tools and workshop equipment
required
D 009 401 04 -Cleaning Solution-
Removing
- Turn off the ignition.
- VSEE MORE:
General, Technical data
Repair Information
Wire Routing and Securing
When loosening or removing and installing hydraulic, pneumatic or electrical
lines, draw sketches or take pictures. This will ensure they are installed in
their original positions.
Contact Corrosion
Contact corrosion can occur if incorrect fastene
Bumper Cover Lower Section, Removing and Installing, Audi Q3
Removing
- Remove the front bumper cover. Refer to
→ Chapter "Bumper Cover, Removing and Installing".
- Remove the front bumper cover end plate. Refer to
→ Chapter "Front Bumper Cover End Plate, Removing and
Installing".
- If equipped, disconnect the connector
© 2019-2026 Copyright www.auq3.net | 0.0099
