Audi Q3: Antenna Systems
- Overview - Antenna Systems
- Antenna Amplifier, Removing and Installing
- Roof Antenna, Removing and Installing
- Antenna Amplifier Connector Assignments
READ NEXT:
Overview - Antenna Systems
The antenna system consists of the Roof Antenna -R216- and
the window antenna.
Roof Antenna -R216-
GPS Antenna -R50-, only on 7T2, 7T6 and 7Q4
Telephone Antenna -R65-, only on 9ZF and 9ZW
S
Antenna Amplifier, Removing and Installing
Antenna Amplifier -R24-, Removing and Installing
The Antenna Amplifier -R24- is located on the upper left of
the rear lid.
Removing
- Turn off the ignition and all electrical equipment and
Roof Antenna, Removing and Installing
The Roof Antenna -R216- has up to three connectors.
The antenna wires are connected directly to the base of the
Roof Antenna -R216-.
The headliner must be lowered in order to remove the Roof
Ant
SEE MORE:
Charging the 12 volt vehicle battery
Fig. 152 Engine compartment with battery: connections
for charger and jump start cable
Observe the safety precautions.
Requirement: only use chargers with a maximum
charging current of 14.8 volts. The battery cables
remain connected.
The battery is located in the engine compartment.
The ground po
Type Label
The type label for refrigerant and filling capacities is
located on the lock carrier cover.
1 - Refrigerant identification, such as R134a
2 - Refrigerant capacity
3 - Refrigerant oil identification (here PAG oil). For
additional information, refer to
→ Re
© 2019-2025 Copyright www.auq3.net
