Audi Q3: Wiring
- Vehicle Diagnosis, Testing and Information Systems
- Vehicle Electrical System, General Repair Information
- Wiring Harness Repair Set
- Tool Descriptions
- Airbag and Belt Tensioner Wires, Repairing
- 0.22 mm 2 Wire, Repairing with Individual
Crimp Connector
- Repairing a Wire 0.35 mm 2 or Greater with
Individual Crimp Connector
- Repairing a 0.22 mm 2 Wire with Intermediate
Wire Section
- Repair a wiring 0.35 mm 2 or greater with
intermediate wire section
- 10 mm2- or 16 mm2
Wires with Separate Butt Connectors, Repairing
- 2.,5 mm2, 4 mm2 or
6 mm2 Aluminum Wires with Separate Butt Connectors,
Repairing
- Fiber-Optic Cables, Repairing
- Antenna Wires, Repairing
- Connector Housings and Connectors, Repairing
- Connector Housings, Releasing and Disassembling
- Contact Surface Cleaning Set -VAS6410-
- ESD Work Surface -VAS6613-
READ NEXT:
WARNING
During road tests using a vehicle diagnostic and
information system, there is the hazard of extreme to
lethal injuries!
If vehicle diagnostic and information system is
de
Caution
When disconnecting and connecting battery, the
procedure must be followed as described in the Repair
Manual.
WARNING
Some tools are supplied with a tool safety clip,
Wiring Harness Repair Set -VAS1978-
The Wiring Harness Repair Set -VAS1978- makes optimal repair
quality possible in the realm of vehicle electronics. Using the
tools, repairs affecting harness c
SEE MORE:
Special tools and workshop equipment
required
Trim Removal Wedge -3409-
Removing
- Unlock the rear seat backrest.
- Make sure the button -2-
(indicator) is in the "up" position.
- Push the tabs -arrows- on both
sides of the trim using a Trim Removal Wedge -3409-.
-&nb
1 - Suspension Strut
2 - Bolt
70 Nm + 90º
Always replace if removed
Bolt point must face in direction of travel.
3 - Front Speed Sensor
Removing and installing. Refer to
→ Brake System; Rep. Gr.45; Sensors; Front ABS Wheel Speed Sen