Audi Q3: Wheels/Tires/Tire Pressure Monitoring Assembly
Chassis / Audi Q3 (8U) 2011-2018 Service Manual / Wheels/Tires/Tire Pressure Monitoring Assembly
- Wheels and Tires, General Information
- Component Overview - Run-Flat Tire (PAX)
- Wheel, Changing and Mounting
- Installation Instructions, Run-Flat Tires
- Removing Tires, Run-Flat Tires
- Tires, Mounting, Run-Flat Tires
- Tires, Changing
READ NEXT:
Wheels and Tires, General Information
Only install tires with the same manufacturer, construction
type and tread on all wheels.
Always replace rubber valve when replacing steel wheel or
rim.
Install tires with DOT identification fac
Component Overview - Run-Flat Tire (PAX)
Caution
It is mandatory for run-flat tires to have a tire
pressure monitoring system in the vehicle.
Note
Be careful not to scratch off the glued- on wheel trim on
these r
Wheel, Changing and Mounting
Special tools and workshop equipment
required
Torque Wrench 1332 40-200Nm -VAG1332-
Wheel Lock Set -T10101-
Wheel Lock Set -T10101A-
Wheel Lock Set -T40004-
Wheel Lock Set -T40073-
WaxSEE MORE:
Settings
Telephone settings
Applies to: vehicles with telephone
Applies to: MMI: Select on the home screen:
PHONE > .
The following options may be possible, depending
on your mobile device:
Decline with text message
Edit voicemail number
Switching between two mobile devices
Requirement: phone 1 an
Sunroof Frame, Removing and Installing
1 - Bolt
3 Nm
2 - Power Sunroof Control Module -J245-.
Performing the adaptation procedure. Refer to
→ Chapter "Motor Adaptation".
3 - Bolt
8 Nm.
4 - Roof
5 - Panorama Roof Frame
Removing
Headliner remo
© 2019-2026 Copyright www.auq3.net | 0.0118
