Audi Q3: Touch display
Audi Q3 (F3) 2018-2025 Owner's Manual / Display and operation / Touch display
READ NEXT:
General touch display operation
General information
Applies to: touch display
The center display is a touchscreen. Operation is very similar to operating a
smartphone.
Tips
Certain gestures are not available in every
menu.
Pressing
Multi Media Interface
Traffic safety information
Audi recommends only using certain Infotainment
system functions while the vehicle is stationary,
such as entering a destination or pairing
a mobile device. Always be prepar
Menus and symbols
Fig. 14 MMI: center display
Description of common symbols
You can operate the default functions using the
symbols that follow. The symbols may be found
in any menu, depending on the context.
Go bac
SEE MORE:
Upper Transverse Link, Removing and Installing
Upper Transverse Link, Removing and Installing, FWD Vehicles
Special tools and workshop equipment
required
Torque Wrench 1332 40-200Nm -VAG1332-
Removing
- Measure dimension from center of wheel to lower edge of
wheel housing. Refer to
→ Chapter "Wheel Bearing in Curb Weig
High Pressure Sensor -G65-, Removing and Installing
Note
When the High Pressure Sensor -G65- is removed, the cooling
output cannot be checked. The Climatronic Control Module
-J255-/A/C Control Module -J301- control head does not switch on
the Air Conditioning (A/C) compressor. Refer to Vehicle
Diagnostic Tester in the "Guided Fau
© 2019-2025 Copyright www.auq3.net
