Audi Q3: Display and operation
Display and operation
READ NEXT:
Instrument cluster overview
Fig. 2 Audi virtual cockpit plus overview
Fig. 3 Digital instrument cluster or Audi virtual cockpit overview
Depending on the vehicle equipment, the following
items may appear in the instrument clus
Adjusting the display
Fig. 6 Center display: adjusting the display
Switching the view
Applies to: Audi virtual cockpit
Press the VIEW button to switch between the
default view 1 and the enhanced view 2.
Adjusting the SEE MORE:
Drive Axle, Removing and Installing, Right Drive Axle with CV Joint,
Inserted with Inner Splines
Special tools and workshop equipment
required
Slide Hammer Set -VW771-
Tensioning Strap -T10038-
Puller - Driveshaft -T10382-
Torque Wrench 1332 40-200Nm -VAG1332-
Digital Torque Wrench -VAG1756A-
Removing
- Loosen the drive axle threaded connection on the wheel side.
Refer
Electronic Damping
Overview - Electronic Damping Component Location
Note
The body acceleration sensors may not be interchanged with
each other.
1 - Right Front Body Acceleration Sensor -G342-
Removing and installing. Refer to
→ Chapter "Left/Right Front Body Acceleration Sensor -
© 2019-2026 Copyright www.auq3.net | 0.0134
