Audi Q3: Side Marker Lamp
Overview - Side Marker Lamp
1 - Front Bumper Cover
2 - Rear Side Marker Lamp Bulb
- The entire body tail lamp must be replaced if an LED is faulty
- Left Rear Side Marker Lamp Bulb -M37-, Right Rear Side Marker Lamp Bulb -M38-
- Removing and installing. Refer to → Chapter "Tail Lamp, Removing and Installing".
3 - Rear Bumper Cover
4 - Body Tail Lamp
5 - Front Side Marker Lamp Bulb
- The entire front side marker lamp must be replaced if an LED is faulty
- Left Front Side Marker Lamp Bulb -M33-, Right Front Side Marker Lamp Bulb -M34-
- Removing and installing. Refer to → Chapter "Front Side Marker Lamp, Removing and Installing".
6 - Front Side Marker Lamp
- Removing and installing. Refer to → Chapter "Front Side Marker Lamp, Removing and Installing".
Front Side Marker Lamp, Removing and Installing
Removing
- Turn the light switch to position "0".
- Loosen the front wheel housing liner in the front area and push it aside. Refer to → Body Exterior; Rep. Gr.66; Wheel Housing Liner; Front Wheel Housing Liner, Removing and Installing.
- Release the retainer -2-, pivot the side marker lamp -1- out of the opening -arrow- and remove it from the mount.
- Disconnect the connector -3-.
Installing
Install in reverse order of removal. Note the following:
- Install the side marker lamp into the opening and lock it on the opposite side.
READ NEXT:
Exterior Rearview Mirror Lamps
Overview - Exterior Rearview Mirror Lamps
1 - Mirror Glass
2 - Mirror Adjusting Unit Mount
3 - Exterior Rearview Mirror Housing
4 - Exterior Rearview Mirr
Tail Lamps
Overview - Rear Lid Tail Lamps
LED tail lamps have LED bulbs and are integrated in the tail
lamps. The LEDs cannot be replaced; the entire tail lamp must be
replaced.
1 - Tail L
High-Mounted Brake Lamp
Overview - High-Mounted Brake Lamp
1 - High-Mounted Brake Lamp
High-Mounted Brake Lamp Bulb -M25-
Removing and installing. Refer to
→ Chapter "High-Mounted Brake Lamp Bulb,SEE MORE:
Safety systems monitoring
The
indicator light in the instrument cluster
monitors the safety systems such as the airbags
(including the control modules, sensor, and wiring)
and the belt tensioners. It turns on when you
switch the ignition on and turns off after several
seconds.
If the indicator light does not turn on when
Passenger Occupant Detection System
Component Location Overview - Passenger Occupant Detection System
WARNING
The replacement part (service kit) for the passenger
occupant detection system is already precalibrated and must not
be separated under any circumstances. The service kit consists
of:
Passenger Occupant D