Audi Q3: Exterior Rearview Mirror Lamps
Overview - Exterior Rearview Mirror Lamps
1 - Mirror Glass
2 - Mirror Adjusting Unit Mount
3 - Exterior Rearview Mirror Housing
4 - Exterior Rearview Mirror Turn Signal Bulb
- Driver Exterior Rearview Mirror Turn Signal Bulb -L131-
- Front Passenger Exterior Rearview Mirror Turn Signal Bulb -L132-
- Removing and installing. Refer to → Chapter "Driver/Front Passenger Exterior Rearview Mirror Turn Signal Bulb -L131-/-L132-, Removing and Installing".
5 - Bolt
- 0.9 Nm
Driver/Front Passenger Exterior Rearview Mirror Turn Signal Bulb -L131-/-L132-, Removing and Installing
Removing
- Remove the exterior rearview mirror housing. Refer to → Body exterior; Rep. Gr.66; Overview - Exterior Rearview Mirror.
- Remove the bolts -2 and 3-.
- Pry the turn signal bulb housing -4- with a narrow screwdriver -1- from the mount in direction of -arrow A- and at the same time pivot out the exterior rearview mirror housing in direction of -arrow B-.
Installing
Install in reverse order of removal. Note the following:
Note
The entire exterior mirror turn signal must be replaced if an LED is faulty.
- Insert the tip of the turn signal in the slit in the exterior rearview mirror housing -3- in direction of -arrow A-.
- Tilt the turn signal bulb housing -4- into the exterior rearview mirror housing in direction of -arrow B-. The locking tab -2- must engage in the mount -1-.
- Install the exterior rearview mirror housing. Refer to → Body exterior; Rep. Gr.66; Overview - Exterior Rearview Mirror.
READ NEXT:
Tail Lamps
Overview - Rear Lid Tail Lamps
LED tail lamps have LED bulbs and are integrated in the tail
lamps. The LEDs cannot be replaced; the entire tail lamp must be
replaced.
1 - Tail L
High-Mounted Brake Lamp
Overview - High-Mounted Brake Lamp
1 - High-Mounted Brake Lamp
High-Mounted Brake Lamp Bulb -M25-
Removing and installing. Refer to
→ Chapter "High-Mounted Brake Lamp Bulb,
Component Location Overview - Access/Start Authorization System
1 - Electronic Steering Column Lock Control Module -J764-
Overview. Refer to
→ Chapter "Overview - Steering Column Switch Module, with Electronic
Ignition Switch".
2 SEE MORE:
Windshield washer system
Fig. 153 Engine compartment: washer fluid reservoir cap
Observe the safety precautions.
The windshield washer reservoir
contains the
cleaning solution for the windshield/rear window
and the headlight washer system
fig. 153.
To reduce the risk of lime scale deposits on the
spray nozzles, use c
Uniform tire quality grading
Tread wear
Traction AAA BC
Temperature ABC
Quality grades can be found where applicable on
the tire side wall between tread shoulder and
maximum section width fig. 154.
For example: Tread wear 200, Traction AA, Temperature
A.
All passenger car tires must conform to Federal
Safety Requirement