Audi Q3: Seat Frames
Body / Audi Q3 (8U) 2011-2018 Service Manual / Seat Frames
- Overview - Seat Versions
- Component Location Overview - Electric and Electronic Components
- Overview - Front Seat
- Overview - Front Backrest
- Overview - Seat Pan
- Overview - Seat Pan, Sill Panel/Tunnel Side Seat Side Trim on Power Front Seat
- Overview - Seat Pan, Drawer
- Front Seat, Removing and Installing
- Airbag Adapter, Connecting and Disconnecting
- Seat Height Adjuster, Removing and Installing
- Seat Angle Adjuster, Removing and Installing
- Backrest Adjuster, Removing and Installing
- Front Backrest, Removing and Installing
- Headrest, Removing and Installing
- Modular Wiring Routing with Corrugated Tube
- Seat Side Trim on the Tunnel Side, Removing and Installing
- Seat Depth Adjuster, Removing and Installing
- Backrest Release, Removing and Installing
- Overview - Bench Seat/Single Seat
- Bench Seat/Single Seat, Removing and Installing
- Rear Seat Backrest, Removing and Installing
- Locking Mechanism Trim, Removing and Installing
- Center Armrest, Removing and Installing
READ NEXT:
Overview - Seat Versions
Component Location Overview - Seat Versions
1 - Front Passenger Seat
Standard Seat/Sport Seat (Manual)
Vehicles with:
Seat/backrest heating
Lumbar Support
Standard seat drawer
Component Location Overview - Electric and Electronic Components
Component Location Overview - Electric and Electronic Components, Manual
Front Seat
1 - Left Front Seat Heating Element -Z45-/Driver Backrest Heating
Element -Z7-
Front passenger
Overview - Front Seat
Overview - Front Seat, Manual Standard Seat/Sport Seat
1 - Seat Angle Adjuster
Only for Sport seats
Overview. Refer to
→ Chapter "Overview - Seat Pan, Seat Angle Adjuster".SEE MORE:
Check Valve, Checking
Check valve is removed, refer to
→ Chapter "Check Valve, Removing and Installing".
Note
The check valve is installed directly in front of the vacuum
pump.
Valve must allow air to flow in direction of arrow.
Valve must remain closed in opposite direction.
Sunlight Photo Sensor -G107-, Removing and Installing
Note
The Sunlight Photo Sensor -G107- is only installed with an
automatic climate control system.
Check the Sunlight Photo Sensor -G107- using the Vehicle
Diagnostic Tester in the "Guided Fault Finding" function, A/C
system.
Removing
- Using a 0.4 mm feeler gauge -1-,
© 2019-2026 Copyright www.auq3.net | 0.0111
