Audi Q3: Interrupting the park assist
Applies to: vehicles with park assist
Park assist will be canceled automatically in the following scenario:
- You switch the system off.
- You start steering.
- The speed is too high.
- The time limit is exceeded.
- An obstacle is detected.
- ESC intervenes.
Resume control of the vehicle, end the park assist manually, or:
- You can resume the parking process in some
situations. Press the
.png)
button
in the center
console. - To continue exiting the parking space, switch
the engine off and on. Press the
.png)
button in
the center console.
WARNING
Observe the safety precautions and note the limits of the assist systems, sensors, and cameras.
Messages
Applies to: vehicles with park assist
If the .png)
,
.png)
or
.png)
indicator light turns on, the
park assist is not available or was interrupted.
A message that indicates the cause and possible solution may appear with some displays. The weather conditions may be too poor or a sensor may be covered. Clean the area in front of the sensors and try to turn the system on again later.
If the malfunction remains, drive to an authorized Audi dealer or authorized Audi Service Facility immediately to have the malfunction corrected.
READ NEXT:
Introduction
Applies to: vehicles with telephone
You can operate various telephone functions easily
through the MMI in your vehicle.
Depending on the country and the vehicle equipment,
the following options may bSEE MORE:
Center Console, Removing and Installing
Center Console, Removing and Installing
Removing
- Remove the center console insert. Refer to
→ Chapter "Center Console Insert, Removing and Installing".
- Versions with Access/Start Authorization Button -E408-:
Remove the front storage compartment. Refer to
→ Chapter
Overview - Battery
Overview - Battery, Engine Compartment Battery Version 1
1 - Battery Tray
Removing and installing. Refer to
→ Chapter "Battery Tray, Removing and Installing, Version 1".
2 - Retaining Bracket
There are different versions. Refer to the Parts Catalog.
3&nb