Center Grille. Removing and Installing, Audi Q3 Offroad
Removing
- Remove the noise insulation. Refer to → Chapter "Overview - Noise Insulation".
- Remove the front bumper cover end plate. Refer to → Chapter "Front Bumper Cover End Plate, Removing and Installing".
- Remove the bolts -arrows-.
- Disconnect the connector -4- and set aside the bracket -3- with the Outside Air Temperature Sensor -G17-.
- Loosen the catch -2- on the upper side of the reinforcement brace -1-.
- Remove the reinforcement brace.
Note
The catches are not accessible.
Installing
Install in reverse order of removal. Note the following:
- Install the front bumper cover end plate. Refer to → Chapter "Front Bumper Cover End Plate, Removing and Installing".
Center Grille, Removing and Installing, Audi Q3 S Line through MY 2014
Removing
- Remove the noise insulation. Refer to → Chapter "Overview - Noise Insulation".
- Remove the front bumper cover end plate. Refer to → Chapter "Front Bumper Cover End Plate, Removing and Installing".
- Remove the bolts -arrows-.
- Disconnect the connector -5- and set aside the bracket -4- with the Outside Air Temperature Sensor -G17-.
- Lift the tab -2- and unlock the tabs -1-.
- Remove the center grille -3-.
Installing
Install in reverse order of removal.
Center Grille, Removing and Installing, Audi Q3 from MY 2015
Removing
- Remove the noise insulation. Refer to → Chapter "Overview - Noise Insulation".
- Remove the front bumper cover end plate. Refer to → Chapter "Front Bumper Cover End Plate, Removing and Installing".
- Remove the bolts -arrows-.
- Set the bracket -4- with the Outside Air Temperature Sensor - G17- to the side.
- Release the tab -1- and lift up the securing tab -2- slightly.
- Remove the center grille -3- toward the front.
Installing
Install in reverse order of removal.
READ NEXT:
Bumper Cover Lower Section, Removing and Installing, Audi Q3
Removing
- Remove the front bumper cover. Refer to
→ Chapter "Bumper Cover, Removing and Installing".
- Remove the front bumper cover end plate. Refer to
→ Chapter "Front
Molded Foam Part, Removing and Installing, Audi Q3 through MY 2014
Removing
- Remove the front bumper cover. Refer to
→ Chapter "Bumper Cover, Removing and Installing".
- Guide the molded foam piece -2-
at the top out of the bracket -arrow-
a
Air Intake Grille Trim, Removing and Installing
Removing
- Remove the air intake grille. Refer to
→ Chapter "Air Intake Grille, Removing and Installing, Vehicles
through MY 2014".
- Remove the front bumper cover. Refer to
âSEE MORE:
Traffic incidents
Introduction
Applies to: vehicles with navigation system and online traffic
information
Fig. 135 Traffic information overview
Open traffic information
Requirement: the map must be displayed.
Press on the traffic jam symbol in the side
menu on the map fig. 131.
Display traffic report details
Tire pressure
Fig. 156 Driver's side B-pillar: tire pressure
label
Fig. 157 Tire pressure label
The correct tire pressure for tires
installed at the factory is listed on
a label. The label is located on the
B-pillar (driver's side) fig. 156,
fig. 157.
Use the tire pressure specified for
a normal vehicle load