Audi Q3: Removing Tires, Run-Flat Tires
Note
- Be careful not to scratch off the glued- on wheel trim on these rims.
- The surface of the wheel trim is very sensitive.
- The rim will have be replaced if the wheel trim is damaged.
- The wheel trim cannot be replaced.
- Turn wheel on tire mounting device so that tire valve/tire pressure sensor -2- stands in front of mounting head -1-.
Caution
Mounting head -1- must not be located in area -a- of tire valve/tire pressure sensor, otherwise the mounting head will damage the tire pressure sensor.
- Position mounting head -1- in vicinity of tire valve/tire pressure sensor so that tire iron can be put on approximately 30º next to tire valve/tire pressure sensor -2-.
- Install press holders -3- on disc wheel opposite the mounting head -1-.
- Now pry tire bead over mounting finger on mounting head using tire iron and remove tire iron again.
- Let the tire dismounting/mounting machine run clockwise until upper bead lies completely above the rim flange.
This slides the press holders -1- against the mounting head. This allows them to be removed again easily.
- Turn wheel on tire mounting device so that tire valve/tire pressure sensor -2- stands in front of mounting head -1-.
Caution
Mounting head -1- must not be located in area -a- of tire valve/tire pressure sensor, otherwise the mounting head will damage the tire pressure sensor.
- Position mounting head -1- in vicinity of tire valve/tire pressure sensor so that tire iron can be put on approximately 30º next to tire valve/tire pressure sensor -2-.
- Now pry tire bead over mounting finger of mounting head using tire iron -3-.
- In addition, insert a plastic mounting lever -4-.
- Remove tire iron -3- again.
- Using plastic mounting lever -1-, hold bead in place over the rim flange from outside and let tire mounting device run clockwise until tire has been pulled off completely from disc wheel.
Note
- Check tire pressure sensor for loose or damaged parts. If threaded connections are loose, union nut, valve insert, seal, sealing washer and valve cap must be replaced by new parts from repair set Parts Catalog.
- If tire pressure sensor is damaged, then it must be replaced completely.
READ NEXT:
Tires, Mounting, Run-Flat Tires
Caution
It is mandatory for run-flat tires to have a tire
pressure monitoring system in the vehicle.
- Coat rim flanges, tire beads and inside of upper tire beads
thoroughly with
Tires, Changing
The valve insert must be replaced with every tire change.
Metal valve and wheel electronics can be reused.
- Let air out of tire by removing the valve insert.
Note
Be careful not
Wheel Electronics, New Design
Assembly Sequence
- Fold the valve -1- downward
-arrow A toward B-.
- Slide the valve with the wheel electronics attached through
the valve opening in the rim.
- Rotate the unioSEE MORE:
Predictive control
Applies to: vehicles with adaptive cruise assist and predictive
control
General information
With predictive control, efficiency assist adapts
the speed set in the adaptive cruise control 1
fig. 97 based on detected speed limits
and the upcoming route. Once the system no
longer detects any relevant
Emergency assist
Description
Applies to: vehicles with emergency assist
General information
Within the limits of the system, emergency assist
can detect inactivity from the driver. In these instances,
the system will warn the driver, assume
control of the vehicle if necessary, and bring the
vehicle automatically to 