Audi Q3: Stopovers and route plan
Applies to: vehicles with navigation system
You can enter additional destinations during active route guidance.
Entering a stopover
Requirement: route guidance must be active.
- Enter a destination.
Displaying stopovers or the route plan
All destinations are listed in the route plan.
- Press on
.png)
in the side menu
on the map
.png)
fig. 131.
Editing stopovers
- Press on Fin the side menu on the map
.png)
fig. 131. - Adding a stopover: Select: Add destination select a destination > Add to route.
- Moving a stopover: press
.png)
.
Touch the .png)
symbol
and move the entry to the desired position.Press Done.
- Deleting a stopover: Select:
.png)
> one or more
entries or Select all > Delete > (Done).
Stopping route guidance
Applies to: vehicles with navigation system
Requirement: route guidance must be active and the map must be displayed.
- Applies to: MMI: Press
.png)
.png)
fig. 131. - Select in the instrument cluster: Navigation tab
>
.png)
button > Cancel route
guidance.
READ NEXT:
Map
Map function
Applies to: vehicles with navigation system
Fig. 131 Active route quidance
Fig. 132 Marked map object
Opening the map
Applies to: MMI: Press NAVIGATION on the
home screen.
If neces
Predictive route guidance
Applies to: vehicles with navigation system and predictive
route guidance
Your MMI can learn the routes that you drive frequently
(such as your daily commute to work and
back) and suggest route guidan
Alternative routes
Applies to: vehicles with navigation system
Fig. 134 Alternative routes in the overview map
Opening alternative routes
Requirement: route guidance must be started
and the map must be displayed.
Pre
SEE MORE:
Refrigerant Circuit, Checking Pressure with Service Station
General Information
Note
All test conditions marked are vehicle-specific and are
described in the Repair Manual for the relevant vehicle.
Check cooling performance.
Connections with valve and service connections for
measurement and testing. Refer to
→ Heating, Ventilat
Release Cable, Removing and Installing
Release Cable Coupling
- Remove clips -1- and lift the release
cables -8- and -9-
on both sides toward the hood latches.
- To remove the coupling -2-, release the
retainers -arrows- on the front of the lock
carrier -3- and push them to the rear out
of the bracket.
- Eng
© 2019-2025 Copyright www.auq3.net
